linux_dsm_epyc7002/drivers/net/wireless/ath/ath10k
Vasanthakumar Thiagarajan dcb02db106 ath10k: Add support for code swap
Code swap is a mechanism to use host memory to store
some fw binary code segment. Ath10k host driver allocates
and loads the code swap binary into the host memory and
configures the target with the host allocated memory
information at the address taken from code swap binary.
This patch adds code swap support for firmware binary.
Code swap binary for firmware bin is available in
ATH10K_FW_IE_FW_CODE_SWAP_IMAGE.

Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
2015-06-30 15:12:47 +03:00
..
bmi.c ath10k: improve logging to include dev id 2014-08-26 19:04:48 +03:00
bmi.h ath10k: Fix BMI communication timeout for QCA99X0 2015-06-30 15:12:46 +03:00
ce.c ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
ce.h ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
core.c ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
core.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
debug.c ath10k: print htt op_version upon driver boot 2015-06-16 13:06:47 +03:00
debug.h ath10k: enable pci soc powersaving 2015-05-22 13:39:28 +03:00
debugfs_sta.c ath10k: add support to send delba 2015-01-13 16:13:47 +02:00
hif.h ath10k: remove transfer_id from ath10k_hif_cb::tx_completion 2014-12-01 09:13:36 +02:00
htc.c ath10k: replenish htc tx credits always 2015-04-09 14:58:16 +03:00
htc.h ath10k: fix use of multiple blank lines 2014-09-18 10:45:20 +03:00
htt_rx.c ath10k: remove unused variable hdr in ath10k_htt_rx_h_undecap() 2015-06-16 13:12:19 +03:00
htt_tx.c ath10k: rework tx queue locking 2015-04-01 20:31:00 +03:00
htt.c ath10k: fix HTT op backwards compatibility for QCA6174 2015-03-30 14:56:06 +03:00
htt.h ath10k: fix no-ack frame status 2015-04-09 15:11:30 +03:00
hw.c ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
hw.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
Kconfig ath10k: ATH10K_DEBUGFS depends on DEBUG_FS 2014-09-10 14:17:45 +03:00
mac.c ath10k: mac: remove unreachable negative return check 2015-06-16 13:14:26 +03:00
mac.h ath10k: implement tx pause wmi event 2015-04-01 20:31:08 +03:00
Makefile ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
p2p.c ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
p2p.h ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
pci.c ath10k: Add chip reset sequence for QCA99X0 2015-06-30 15:12:42 +03:00
pci.h ath10k: Make target cpu address to CE address conversion chip specific 2015-06-30 15:12:40 +03:00
rx_desc.h ath10k: add hw rate definitions 2015-03-30 15:09:15 +03:00
spectral.c ath10k: increase relay buffer size of spectral scan 2015-05-11 17:50:42 +03:00
spectral.h ath10k: clean up phyerr code 2014-09-23 12:31:54 +03:00
swap.c ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
swap.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
targaddrs.h ath10k: Add hw register/values for QCA99X0 chip 2015-06-30 15:12:37 +03:00
testmode_i.h ath10k: add testmode 2014-09-11 23:42:36 +03:00
testmode.c ath10k: introduce wmi ops 2014-12-08 17:39:08 +02:00
testmode.h ath10k: add testmode 2014-09-11 23:42:36 +03:00
thermal.c ath10k: don't call quiet mode if it's not implemented 2015-04-01 20:21:17 +03:00
thermal.h ath10k: configure thermal throttle while powering up 2015-03-23 17:16:37 +02:00
trace.c
trace.h ath10k: add extra check for frame tracing 2015-04-17 09:33:48 +03:00
txrx.c ath10k: txrx: remove unreachable negative return check and fixup type 2015-06-16 13:14:54 +03:00
txrx.h ath10k: fix Rx aggregation reordering 2014-07-25 11:15:39 +03:00
wmi-ops.h ath10k: implement adaptive qcs command 2015-04-01 20:30:52 +03:00
wmi-tlv.c ath10k: prevent memory leak in wmi rx ops 2015-06-09 13:49:33 +03:00
wmi-tlv.h ath10k: implement tx pause wmi event 2015-04-01 20:31:08 +03:00
wmi.c ath10k: prevent memory leak in wmi rx ops 2015-06-09 13:49:33 +03:00
wmi.h ath10k: move cycle_count macro 2015-05-29 17:34:19 +03:00
wow.c ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00
wow.h ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00