AFTR mode support brings reduced energy consumption and is
a prerequisite for more advanced W-AFTR/LPA power saving modes.
AFTR mode has been already supported on other Exynos SoCs for
few years and this patch adds its support for Exynos3250 SoC.
The differences in Exynos3250 SoC AFTR mode support when compared
to Exynos4x12 SoCs are:
- different secure firmware calls are used
- different S5P_WAKEUP_MASK wakeup mask is used
- S5P_WAKEUP_MASK2 wakeup mask needs to be set in addition to
the standard S5P_WAKEUP_MASK one
- C2_STATE BOOT mode flag needs to be set/cleared pre/post AFTR
Cc: Daniel Lezcano <daniel.lezcano@linaro.org>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
Acked-by: Kyungmin Park <kyungmin.park@samsung.com>
Tested-by: Chanwoo Choi <cw00.choi@samsung.com>
Signed-off-by: Kukjin Kim <kgene@kernel.org>
CPU1 hotplug may hang when AFTR is used. Fix it by:
- setting AUTOWAKEUP_EN bit in ARM_COREx_CONFIGURATION register in
exynos_cpu_power_up()
- not clearing reserved bits of ARM_COREx_CONFIGURATION register in
exynos_cpu_power_down()
- waiting while an undocumented register 0x0908 becomes non-zero in
exynos_core_restart()
- using dsb_sev() instead of IPI in exynos_boot_secondary() on
Exynos3250
This patch also fixes hotplug issues during resume from S2R:
$ echo mem > /sys/power/state
[ 156.517266] Disabling non-boot CPUs ...
[ 156.517781] IRQ18 no longer affine to CPU1
[ 156.518043] CPU1: shutdown
[ 156.544718] Enabling non-boot CPUs ...
[ 156.554925] CPU1: Software reset
[ 158.552631] CPU1: failed to come online
[ 158.552753] Error taking CPU1 up: -5
Cc: Daniel Lezcano <daniel.lezcano@linaro.org>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
Reviewed-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Tested-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Acked-by: Kyungmin Park <kyungmin.park@samsung.com>
Tested-by: Chanwoo Choi <cw00.choi@samsung.com>
Signed-off-by: Kukjin Kim <kgene@kernel.org>
This patch supports suspend-to-ram for Exynos3250 SoC
and the SoC doesn't contain L2 cache.
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Acked-by: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Kukjin Kim <kgene@kernel.org>
Adds initial PMU settings for exynos5420. This is required for
future S2R and Switching support.
Signed-off-by: Thomas Abraham <thomas.ab@samsung.com>
Signed-off-by: Abhilash Kesavan <a.kesavan@samsung.com>
Signed-off-by: Vikas Sajjan <vikas.sajjan@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Without software reset the secondary CPU does not power up and
exynos_boot_secondary() ends with pen_release equal to 1. This can be
observed in dmesg:
CPU1: failed to come online
Brought up 1 CPUs
SMP: Total of 1 processors activated.
CPU: All CPU(s) started in SVC mode.
When booting the secondary CPU on Exynos3250 execute also software
reset for core 1.
Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Refactoring the pm.c to avoid using "soc_is_exynos" checks,
instead use the DT based lookup.
While at it, consolidate the common code across SoCs
and create static helper functions.
Signed-off-by: Vikas Sajjan <vikas.sajjan@samsung.com>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
On Exynos4 USE_DELAYED_RESET_ASSERTION must be set in
ARM_COREx_OPTION register during CPU power down. This is the proper way
of powering down CPU on Exynos4.
Additionally on Exynos4212 without this the CPU clock down feature won't
work after powering down some CPU and the online CPUs will work at full
frequency chosen by CPUfreq governor.
Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Under "arm/mach-exynos" many files are using PMU register offsets.
Since we have added support for accessing PMU base address via DT,
now we can remove PMU mapping from exynosX_iodesc. Let's convert
all these access using iomapped address.
This will help us in removing static mapping of PMU base address
as well as help in reducing dependency over machine header files.
Thus helping for migration of PMU implementation from machine to
driver folder which can be reused for ARM64 based SoC.
Also as we have removed static mappings from "regs-pmu.h" it does
not need map.h anymore. But "platsmp.c" needed this and till now it
got included indirectly. So lets move header inclusion of
"mach/map.h" from "regs-pmu.h" to "platsmp.c".
Signed-off-by: Pankaj Dubey <pankaj.dubey@samsung.com>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Turning off a cluster when all 4 cores of the cluster are powered off
saves power significantly. Powering off the A15 L2 alone gives around
100mW in savings. Add support for powering off the A15/A7 clusters on
exynos5420/5800.
The patch enables specific register bits which ensure that:
- cluster L2 will be turned on before the first man is powered up.
- last man will be turned off before the cluster L2 is turned off.
- core is powered down before powering it up.
Remove the exynos_cluster_power_control function completely as we can
rely on the above mentioned bits rather than polling the cluster power
status register.
Signed-off-by: Abhilash Kesavan <a.kesavan@samsung.com>
Acked-by: Nicolas Pitre <nico@linaro.org>
Tested-by: Kevin Hilman <khilman@linaro.org>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
The address of cpu power registers in pmu is based on cpu number
offsets. This function calculate the same. This is essentially
required in case of multi-cluster SoC's e.g Exynos5420.
Signed-off-by: Chander Kashyap <chander.kashyap@linaro.org>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Current "pm_domain.c" file uses "S5P_INT_LOCAL_PWR_EN" definition from
"regs-pmu.h" and hence needs to include this header file. As there is
no other user of "S5P_INT_LOCAL_PWR_EN" definition other than pm_domain,
to remove "regs-pmu.h" header file dependency from "pm_domain.c" it's
better we define this definition in "pm_domain.c" file itself and thus it
will help in removing header file inclusion from "pm_domain.c".
Also removing "S5P_" prefix from macro.
Signed-off-by: Pankaj Dubey <pankaj.dubey@samsung.com>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
While making PMU implementation to be device tree based, there are
few register offsets related with SYSREG present in regs-pmu.h, so
let's make a new header file "regs-sys.h" to keep all such SYSREG
related register offsets and remove them from "regs-pmu.h"
Signed-off-by: Pankaj Dubey <pankaj.dubey@samsung.com>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
This macro is only used there.
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Reviewed-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Add machine-dependent MCPM call-backs for Exynos5420. These are used
to power up/down the secondary CPUs during boot, shutdown, s2r and
switching.
Signed-off-by: Thomas Abraham <thomas.ab@samsung.com>
Signed-off-by: Inderpal Singh <inderpal.s@samsung.com>
Signed-off-by: Andrew Bresticker <abrestic@chromium.org>
Signed-off-by: Abhilash Kesavan <a.kesavan@samsung.com>
Reviewed-by: Nicolas Pitre <nicolas.pitre@linaro.org>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Add generic cluster power control functions for exynos based SoCS
for cluster power up/down and to know the cluster status.
Signed-off-by: Abhilash Kesavan <a.kesavan@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Use generic exynos cpu power control functions to power up/down
and to know the status of the cpu in platsmp and hotplug code.
Signed-off-by: Leela Krishna Amudala <leela.krishna@linaro.org>
Signed-off-by: Abhilash Kesavan <a.kesavan@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Add generic cpu power control functions for exynos based
SoCS for cpu power up/down and to know the cpu status.
Signed-off-by: Leela Krishna Amudala <leela.krishna@linaro.org>
Signed-off-by: Abhilash Kesavan <a.kesavan@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Since Exynos SoCs does not follow most of the semantics of older SoCs
when configuring the system to enter sleep, there is no reason to rely
on the legacy Samsung PM core anymore.
This patch adds local Exynos suspend ops and removes all the code left
unnecessary. As a side effect, suspend support on Exynos becomes
multiplatform-friendly.
Signed-off-by: Tomasz Figa <t.figa@samsung.com>
Acked-by: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
Since there is very little difference between these two files,
they can be easily combined into one with necessary SoC checks.
While at it also merge the common.c file into this as it does
not have any other users.
Signed-off-by: Sachin Kamat <sachin.kamat@linaro.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>
