linux_dsm_epyc7002/drivers/pinctrl
Icenowy Zheng c8a8309049 pinctrl: sunxi: add support for the Allwinner H6 main pin controller
The Allwinner H6 SoC has two pin controllers, one main controller
(called CPUX-PORT in user manual) and one controller in CPUs power
domain (called CPUS-PORT in user manual).

This commit introduces support for the main pin controller on H6.

The pin bank A and B are not wired out and hidden from the SoC's
documents, however it's shown that the "ATE" (an AC200 chip
co-packaged with the H6 die) is connected to the main SoC die via these
pin banks. The information about these banks is just copied from the BSP
pinctrl driver, but re-formatted to fit the mainline pinctrl driver
format. The GPIO functions are dropped, as they're impossible to use --
except a GPIO&IRQ only pin (PB20) which might be the IRQ of ATE.

Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
Acked-by: Rob Herring <robh@kernel.org>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2018-03-27 15:09:42 +02:00
..
aspeed
bcm
berlin
freescale pinctrl: imx: Add pinctrl driver support for imx6sll 2018-03-23 04:16:10 +01:00
intel pinctrl: intel: Implement intel_gpio_get_direction callback 2018-03-23 04:07:22 +01:00
mediatek pinctrl: mtk: fix check warnings. 2018-03-26 10:58:33 +02:00
meson pinctrl: meson: meson8b: fix requesting GPIOs greater than GPIOZ_3 2018-03-02 10:46:42 +01:00
mvebu This is the bulk of pin control changes for the v4.16 kernel cycle: 2018-02-02 14:22:53 -08:00
nomadik pinctrl: nomadik: Drop U8540/9540 support 2018-03-23 03:38:14 +01:00
pxa
qcom pinctrl: msm8998: Remove owner assignment from platform_driver 2018-03-27 14:05:11 +02:00
samsung
sh-pfc pinctrl: sh-pfc: r8a77995: Deduplicate VIN4 pin definitions 2018-03-21 18:25:48 +01:00
sirf
spear
sprd pinctrl: sprd: Use seq_putc() in sprd_pinconf_group_dbg_show() 2018-01-16 11:08:24 +01:00
stm32 pinctrl: stm32: add 'depends on HAS_IOMEM' to fix unmet dependency 2018-03-23 04:04:40 +01:00
sunxi pinctrl: sunxi: add support for the Allwinner H6 main pin controller 2018-03-27 15:09:42 +02:00
tegra
ti
uniphier pinctrl: uniphier: divide I2S and S/PDIF audio out pin-mux group 2018-03-27 13:36:15 +02:00
vt8500
zte
core.c pinctrl: core: Add missing EXPORT on pinctrl_register_mappings 2018-03-02 11:05:35 +01:00
core.h
devicetree.c pinctrl: devicetree: Fix dt_to_map_one_config handling of hogs 2018-03-02 09:41:21 +01:00
devicetree.h
Kconfig pinctrl: Drop TZ1090 drivers 2018-03-01 15:34:15 +01:00
Makefile pinctrl: Drop TZ1090 drivers 2018-03-01 15:34:15 +01:00
pinconf-generic.c
pinconf.c
pinconf.h
pinctrl-adi2-bf54x.c
pinctrl-adi2-bf60x.c
pinctrl-adi2.c
pinctrl-adi2.h
pinctrl-amd.c pinctrl/amd: poll InterruptEnable bits in enable_irq 2018-03-26 11:09:49 +02:00
pinctrl-amd.h
pinctrl-artpec6.c pinctrl: artpec-6: Add smaller groups for uarts 2018-03-01 17:04:09 +01:00
pinctrl-as3722.c
pinctrl-at91-pio4.c
pinctrl-at91.c
pinctrl-at91.h
pinctrl-axp209.c
pinctrl-coh901.c
pinctrl-coh901.h
pinctrl-da850-pupd.c
pinctrl-digicolor.c
pinctrl-falcon.c
pinctrl-gemini.c This is the bulk of pin control changes for the v4.16 kernel cycle: 2018-02-02 14:22:53 -08:00
pinctrl-ingenic.c pinctrl: ingenic: Remove redundant dev_err call in ingenic_pinctrl_probe() 2018-01-18 08:51:32 +01:00
pinctrl-lantiq.c
pinctrl-lantiq.h
pinctrl-lpc18xx.c
pinctrl-max77620.c
pinctrl-mcp23s08.c pinctrl: mcp23s08: add open drain configuration for irq output 2018-02-22 16:08:59 +01:00
pinctrl-ocelot.c pinctrl: ocelot: fix gpio direction 2018-03-26 11:04:48 +02:00
pinctrl-oxnas.c
pinctrl-palmas.c
pinctrl-pic32.c
pinctrl-pic32.h
pinctrl-pistachio.c
pinctrl-rk805.c
pinctrl-rockchip.c
pinctrl-rza1.c
pinctrl-single.c pinctrl: pinctrl-single: Fix pcs_request_gpio() when bits_per_mux != 0 2018-03-26 10:48:17 +02:00
pinctrl-st.c
pinctrl-sx150x.c pinctrl: sx150x: Add a static gpio/pinctrl pin range mapping 2018-01-18 11:04:47 +01:00
pinctrl-tb10x.c
pinctrl-u300.c
pinctrl-utils.c
pinctrl-utils.h
pinctrl-xway.c
pinctrl-zynq.c
pinmux.c pinctrl: pinmux: Use seq_putc() in pinmux_pins_show() 2018-01-16 11:07:18 +01:00
pinmux.h