mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-06 09:46:40 +07:00
8c03356a55
This patch (as738b) fixes numerous problems in the controller/root-hub suspend/resume/remote-wakeup support in ehci-hcd: The bus_resume() routine should wake up only the ports that were suspended by bus_suspend(). Ports that were already suspended should remain that way. The interrupt mask is used to detect loss of power in the bus_resume() routine (if the mask is 0 then power was lost). However bus_suspend() always sets the mask to 0. Instead the mask should retain its normal value, with port-change-detect interrupts disabled if remote wakeup is turned off. The interrupt mask should be reset to its correct value at the end of bus_resume() regardless of whether power was lost. bus_resume() reinitializes the operational registers if power was lost. However those registers are not in the aux power well, hence they can lose their values whenever the controller is put into D3. They should always be reinitialized. When a port-change interrupt occurs and the root hub is suspended, the interrupt handler should request a root-hub resume instead of starting up the controller all by itself. There's no need for the interrupt handler to request a root-hub resume every time a suspended port sends a remote-wakeup request. The pci_resume() method doesn't need to check for connected ports when deciding whether or not to reset the controller. It can make that decision based on whether Vaux power was maintained. Even when the controller does not need to be reset, pci_resume() must undo the effect of pci_suspend() by re-enabling the interrupt mask. If power was lost, pci_resume() must not call ehci_run(). At this point the root hub is still supposed to be suspended, not running. It's enough to rewrite the command register and set the configured_flag. Signed-off-by: Alan Stern <stern@rowland.harvard.edu> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de> |
||
---|---|---|
.. | ||
ehci-au1xxx.c | ||
ehci-dbg.c | ||
ehci-fsl.c | ||
ehci-fsl.h | ||
ehci-hcd.c | ||
ehci-hub.c | ||
ehci-mem.c | ||
ehci-pci.c | ||
ehci-q.c | ||
ehci-sched.c | ||
ehci.h | ||
hc_crisv10.c | ||
hc_crisv10.h | ||
isp116x-hcd.c | ||
isp116x.h | ||
Kconfig | ||
Makefile | ||
ohci-at91.c | ||
ohci-au1xxx.c | ||
ohci-dbg.c | ||
ohci-ep93xx.c | ||
ohci-hcd.c | ||
ohci-hub.c | ||
ohci-lh7a404.c | ||
ohci-mem.c | ||
ohci-omap.c | ||
ohci-pci.c | ||
ohci-pnx4008.c | ||
ohci-ppc-soc.c | ||
ohci-pxa27x.c | ||
ohci-q.c | ||
ohci-s3c2410.c | ||
ohci-sa1111.c | ||
ohci.h | ||
pci-quirks.c | ||
pci-quirks.h | ||
sl811_cs.c | ||
sl811-hcd.c | ||
sl811.h | ||
u132-hcd.c | ||
uhci-debug.c | ||
uhci-hcd.c | ||
uhci-hcd.h | ||
uhci-hub.c | ||
uhci-q.c |