mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-21 08:46:49 +07:00
fe83b1b7d7
Add these parameters to improve the FLL performance. The comments show as follows: (1)ICTRL_LATCH: FLL DSP speed capability control When FLL running at high frequency with long decimal number, DSP needs to operate at high speed. FLL DSP can optimize between performance and power consumption by ICTRL_LATCH.(111 has highest power consumption.) The default setting can be used to reduce power. (2)CUTOFF500: loop filter cutoff frequency at 500Khz It will give the best FLL performance but highest power consumption to enable the cutoff frequency. FLL Loop Filter enable to reduce FLL output noise, especially,(DCO frequency)/(FLL input reference frequency) is not a integer. (3)GAIN_ERR: FLL gain error correction threshold setting The threshold is comparison between DCO and target frequency. The value 1111 has the most sensitive threshold, that is, 1111 can have the most accurate DCO to target frequency. However, the gain error setting conditionally and inversely depends on FLL input reference clock rate. Higher FLL reference input frequency can only set lower gain error, such as 0000 for input reference from MCLK=12.288Mhz. On the other side, if FLL reference input is from Frame Sync, 48KHz, higher error gain can apply such as 1111. Signed-off-by: John Hsu <KCHSU0@nuvoton.com> Signed-off-by: Mark Brown <broonie@kernel.org> |
||
|---|---|---|
| .. | ||
| aoa | ||
| arm | ||
| atmel | ||
| core | ||
| drivers | ||
| firewire | ||
| hda | ||
| i2c | ||
| isa | ||
| mips | ||
| oss | ||
| parisc | ||
| pci | ||
| pcmcia | ||
| ppc | ||
| sh | ||
| soc | ||
| sparc | ||
| spi | ||
| synth | ||
| usb | ||
| x86 | ||
| ac97_bus.c | ||
| Kconfig | ||
| last.c | ||
| Makefile | ||
| sound_core.c | ||