linux_dsm_epyc7002/drivers/soc/bcm/Kconfig
Stefan Wahren f494caa480 soc: bcm: Make PM driver default for BCM2835
Since commit 52a4adbaebcc ("ARM: bcm283x: Switch V3D over to using the
PM driver instead of firmware.") VC4 on BCM2835 requires the power driver.

Otherwise the driver won't probe and HDMI output stays black:
vc4_v3d 20c00000.v3d: ignoring dependency for device, assuming no driver

Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
Reviewed-by: Eric Anholt <eric@anholt.net>
2019-01-24 19:19:22 +01:00

38 lines
1.1 KiB
Plaintext

menu "Broadcom SoC drivers"
config BCM2835_POWER
bool "BCM2835 power domain driver"
depends on ARCH_BCM2835 || (COMPILE_TEST && OF)
default y if ARCH_BCM2835
select PM_GENERIC_DOMAINS if PM
select RESET_CONTROLLER
help
This enables support for the BCM2835 power domains and reset
controller. Any usage of power domains by the Raspberry Pi
firmware means that Linux usage of the same power domain
must be accessed using the RASPBERRYPI_POWER driver
config RASPBERRYPI_POWER
bool "Raspberry Pi power domain driver"
depends on ARCH_BCM2835 || (COMPILE_TEST && OF)
depends on RASPBERRYPI_FIRMWARE=y
select PM_GENERIC_DOMAINS if PM
help
This enables support for the RPi power domains which can be enabled
or disabled via the RPi firmware.
config SOC_BRCMSTB
bool "Broadcom STB SoC drivers"
depends on ARM || ARM64 || BMIPS_GENERIC || COMPILE_TEST
select SOC_BUS
help
Enables drivers for the Broadcom Set-Top Box (STB) series of chips.
This option alone enables only some support code, while the drivers
can be enabled individually within this menu.
If unsure, say N.
source "drivers/soc/bcm/brcmstb/Kconfig"
endmenu