Johannes Berg df1404650c mac80211: remove support for IFF_PROMISC ... This support is essentially useless as typically networks are encrypted, frames will be filtered by hardware, and rate scaling will be done with the intended recipient in mind. For real monitoring of the network, the monitor mode support should be used instead. Removing it removes a lot of corner cases. Signed-off-by: Johannes Berg <johannes.berg@intel.com>		2015-04-24 11:14:13 +02:00
..
acx.c	lib/crc7: Shift crc7() output left 1 bit	2014-05-16 14:26:52 -04:00
acx.h	wl1251: implement multicast address filtering (fwd)	2014-01-09 10:56:06 -05:00
boot.c	wl1251: retry power save entry	2014-01-09 10:53:38 -05:00
boot.h
cmd.c	lib/crc7: Shift crc7() output left 1 bit	2014-05-16 14:26:52 -04:00
cmd.h	wl1251: split RX and TX data path initialisation	2014-01-09 10:53:39 -05:00
debugfs.c
debugfs.h
event.c	wl1251: only call ieee80211_beacon_loss in managed mode	2014-05-13 15:56:27 -04:00
event.h	wl1251: retry power save entry	2014-01-09 10:53:38 -05:00
init.c	wl1251: implement multicast address filtering (fwd)	2014-01-09 10:56:06 -05:00
init.h
io.c
io.h
Kconfig	Remove GENERIC_HARDIRQ config option	2013-09-13 15:09:52 +02:00
main.c	mac80211: remove support for IFF_PROMISC	2015-04-24 11:14:13 +02:00
Makefile
ps.c	wl1251: don't use [delayed_]work_pending()	2012-12-28 13:40:15 -08:00
ps.h
reg.h
rx.c	wl1251: use skb_trim to make skb shorter	2014-03-03 15:35:55 -05:00
rx.h
sdio.c	wl1251: move power GPIO handling into the driver	2014-02-28 14:08:26 -05:00
spi.c	net: wireless: wl1251: Remove unnecessary free_irq	2014-08-25 16:00:43 -04:00
spi.h
tx.c	wl1251: disable retry and ACK policy for injected packets	2014-01-09 10:56:36 -05:00
tx.h
wl12xx_80211.h
wl1251.h	wl1251: spi: add vio regulator support	2014-02-28 14:08:27 -05:00