mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-28 11:18:45 +07:00
5c113b5e00
The DHT22 (AM2302) datasheet specifies that the LOW start pulse should not
exceed 20ms. However, observations with an oscilloscope of an RPi Model 2B
(rev 1.1) communicating with a DHT22 sensor showed that the driver was
consistently sending start pulses longer than 20ms:
Kernel 4.7.10-v7+ (n=132):
Minimum pulse length: 20.20ms
Maximum: 29.84ms
Mean: 24.96ms
StDev: 2.82ms
Sensor response rate: 100%
Read success rate: 76%
On kernel 4.8, the start pulse was so long that the sensor would not even
respond 97% of the time:
Kernel 4.8.16-v7+ (n=100):
Minimum pulse length: 30.4ms
Maximum: 74.4ms
Mean: 39.3ms
StDev: 10.2ms
Sensor response rate: 3%
Read success rate: 3%
The driver would return ETIMEDOUT and write log messages like this:
[ 51.430987] dht11 dht11@0: Only 1 signal edges detected
[ 66.311019] dht11 dht11@0: Only 0 signal edges detected
Replacing msleep(18) with usleep_range(18000, 20000) made the pulse length
sane again and restored responsiveness:
Kernel 4.8.16-v7+ with usleep_range (n=123):
Minimum pulse length: 18.16ms
Maximum: 20.20ms
Mean: 19.85ms
StDev: 0.51ms
Sensor response rate: 100%
Read success rate: 84%
Cc: stable@vger.kernel.org
Signed-off-by: John Brooks <john@fastquake.com>
Reviewed-by: Harald Geyer <harald@ccbib.org>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>
|
||
|---|---|---|
| .. | ||
| accel | ||
| adc | ||
| amplifiers | ||
| buffer | ||
| chemical | ||
| common | ||
| counter | ||
| dac | ||
| dummy | ||
| frequency | ||
| gyro | ||
| health | ||
| humidity | ||
| imu | ||
| light | ||
| magnetometer | ||
| orientation | ||
| potentiometer | ||
| potentiostat | ||
| pressure | ||
| proximity | ||
| temperature | ||
| trigger | ||
| iio_core_trigger.h | ||
| iio_core.h | ||
| industrialio-buffer.c | ||
| industrialio-configfs.c | ||
| industrialio-core.c | ||
| industrialio-event.c | ||
| industrialio-sw-device.c | ||
| industrialio-sw-trigger.c | ||
| industrialio-trigger.c | ||
| industrialio-triggered-event.c | ||
| inkern.c | ||
| Kconfig | ||
| Makefile | ||