mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-25 22:35:37 +07:00
805f864ebe
6e20a0a429
(gpio: pcf857x: enable gpio_to_irq() support)
added gpio_to_irq() support on pcf857x driver,
but it used pdata->irq.
This patch modifies driver to use client->irq instead of it.
It modifies kzm9g board platform settings,
and device probe information too.
This patch is tested on kzm9g board
Reported-by: Christian Engelmayer <christian.engelmayer@frequentis.com>
Acked-by: Simon Horman <horms+renesas@verge.net.au>
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
45 lines
1.7 KiB
C
45 lines
1.7 KiB
C
#ifndef __LINUX_PCF857X_H
|
|
#define __LINUX_PCF857X_H
|
|
|
|
/**
|
|
* struct pcf857x_platform_data - data to set up pcf857x driver
|
|
* @gpio_base: number of the chip's first GPIO
|
|
* @n_latch: optional bit-inverse of initial register value; if
|
|
* you leave this initialized to zero the driver will act
|
|
* like the chip was just reset
|
|
* @setup: optional callback issued once the GPIOs are valid
|
|
* @teardown: optional callback issued before the GPIOs are invalidated
|
|
* @context: optional parameter passed to setup() and teardown()
|
|
*
|
|
* In addition to the I2C_BOARD_INFO() state appropriate to each chip,
|
|
* the i2c_board_info used with the pcf875x driver must provide its
|
|
* platform_data (pointer to one of these structures) with at least
|
|
* the gpio_base value initialized.
|
|
*
|
|
* The @setup callback may be used with the kind of board-specific glue
|
|
* which hands the (now-valid) GPIOs to other drivers, or which puts
|
|
* devices in their initial states using these GPIOs.
|
|
*
|
|
* These GPIO chips are only "quasi-bidirectional"; read the chip specs
|
|
* to understand the behavior. They don't have separate registers to
|
|
* record which pins are used for input or output, record which output
|
|
* values are driven, or provide access to input values. That must be
|
|
* inferred by reading the chip's value and knowing the last value written
|
|
* to it. If you leave n_latch initialized to zero, that last written
|
|
* value is presumed to be all ones (as if the chip were just reset).
|
|
*/
|
|
struct pcf857x_platform_data {
|
|
unsigned gpio_base;
|
|
unsigned n_latch;
|
|
|
|
int (*setup)(struct i2c_client *client,
|
|
int gpio, unsigned ngpio,
|
|
void *context);
|
|
int (*teardown)(struct i2c_client *client,
|
|
int gpio, unsigned ngpio,
|
|
void *context);
|
|
void *context;
|
|
};
|
|
|
|
#endif /* __LINUX_PCF857X_H */
|