mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-27 04:15:27 +07:00
791d3ef2e1
'interrupt-parent' is often documented as part of define bindings, but it is really outside the scope of a device binding. It's never required in a given node as it is often inherited from a parent node. Or it can be implicit if a parent node is an 'interrupt-controller' node. So remove it from all the binding files. Cc: Mark Rutland <mark.rutland@arm.com> Cc: devicetree@vger.kernel.org Signed-off-by: Rob Herring <robh@kernel.org>
45 lines
1.8 KiB
Plaintext
45 lines
1.8 KiB
Plaintext
* SPEAr Shared IRQ layer (shirq)
|
|
|
|
SPEAr3xx architecture includes shared/multiplexed irqs for certain set
|
|
of devices. The multiplexor provides a single interrupt to parent
|
|
interrupt controller (VIC) on behalf of a group of devices.
|
|
|
|
There can be multiple groups available on SPEAr3xx variants but not
|
|
exceeding 4. The number of devices in a group can differ, further they
|
|
may share same set of status/mask registers spanning across different
|
|
bit masks. Also in some cases the group may not have enable or other
|
|
registers. This makes software little complex.
|
|
|
|
A single node in the device tree is used to describe the shared
|
|
interrupt multiplexor (one node for all groups). A group in the
|
|
interrupt controller shares config/control registers with other groups.
|
|
For example, a 32-bit interrupt enable/disable config register can
|
|
accommodate up to 4 interrupt groups.
|
|
|
|
Required properties:
|
|
- compatible: should be, either of
|
|
- "st,spear300-shirq"
|
|
- "st,spear310-shirq"
|
|
- "st,spear320-shirq"
|
|
- interrupt-controller: Identifies the node as an interrupt controller.
|
|
- #interrupt-cells: should be <1> which basically contains the offset
|
|
(starting from 0) of interrupts for all the groups.
|
|
- reg: Base address and size of shirq registers.
|
|
- interrupts: The list of interrupts generated by the groups which are
|
|
then connected to a parent interrupt controller. Each group is
|
|
associated with one of the interrupts, hence number of interrupts (to
|
|
parent) is equal to number of groups. The format of the interrupt
|
|
specifier depends in the interrupt parent controller.
|
|
|
|
Example:
|
|
|
|
The following is an example from the SPEAr320 SoC dtsi file.
|
|
|
|
shirq: interrupt-controller@b3000000 {
|
|
compatible = "st,spear320-shirq";
|
|
reg = <0xb3000000 0x1000>;
|
|
interrupts = <28 29 30 1>;
|
|
#interrupt-cells = <1>;
|
|
interrupt-controller;
|
|
};
|