Ricardo Neri 9c0b842036 OMAPDSS: Provide an interface for audio support ... There exist several display technologies and standards that support audio as well. Hence, it is relevant to update the DSS device driver to provide an audio interface that may be used by an audio driver or any other driver interested in the functionality. The audio_enable function is intended to prepare the relevant IP for playback (e.g., enabling an audio FIFO, taking in/out of reset some IP, enabling companion chips, etc). It is intended to be called before audio_start. The audio_disable function performs the reverse operation and is intended to be called after audio_stop. While a given DSS device driver may support audio, it is possible that for certain configurations audio is not supported (e.g., an HDMI display using a VESA video timing). The audio_supported function is intended to query whether the current configuration of the display supports audio. The audio_config function is intended to configure all the relevant audio parameters of the display. In order to make the function independent of any specific DSS device driver, a struct omap_dss_audio is defined. Its purpose is to contain all the required parameters for audio configuration. At the moment, such structure contains pointers to IEC-60958 channel status word and CEA-861 audio infoframe structures. This should be enough to support HDMI and DisplayPort, as both are based on CEA-861 and IEC-60958. The omap_dss_audio structure may be extended in the future if required. The audio_enable/disable, audio_config and audio_supported functions could be implemented as functions that may sleep. Hence, they should not be called while holding a spinlock or a readlock. The audio_start/audio_stop function is intended to effectively start/stop audio playback after the configuration has taken place. These functions are designed to be used in an atomic context. Hence, audio_start should return quickly and be called only after all the needed resources for audio playback (audio FIFOs, DMA channels, companion chips, etc) have been enabled to begin data transfers. audio_stop is designed to only stop the audio transfers. The resources used for playback are released using audio_disable. A new enum omap_dss_audio_state is introduced to help the implementations of the interface to keep track of the audio state. The initial state is _DISABLED; then, the state transitions to _CONFIGURED, and then, when it is ready to play audio, to _ENABLED. The state _PLAYING is used when the audio is being rendered. Signed-off-by: Ricardo Neri <ricardo.neri@ti.com>		2012-05-11 15:13:50 +03:00
..
DSS	OMAPDSS: Provide an interface for audio support	2012-05-11 15:13:50 +03:00
omap_pm	omap: opp: add OMAP3 OPP table data and common init	2010-12-21 14:30:40 -08:00