linux_dsm_epyc7002/drivers/mmc
Raul E Rangel 9e4be8d03f mmc: core: Verify SD bus width
The SD Physical Layer Spec says the following: Since the SD Memory Card
shall support at least the two bus modes 1-bit or 4-bit width, then any SD
Card shall set at least bits 0 and 2 (SD_BUS_WIDTH="0101").

This change verifies the card has specified a bus width.

AMD SDHC Device 7806 can get into a bad state after a card disconnect
where anything transferred via the DATA lines will always result in a
zero filled buffer. Currently the driver will continue without error if
the HC is in this condition. A block device will be created, but reading
from it will result in a zero buffer. This makes it seem like the SD
device has been erased, when in actuality the data is never getting
copied from the DATA lines to the data buffer.

SCR is the first command in the SD initialization sequence that uses the
DATA lines. By checking that the response was invalid, we can abort
mounting the card.

Reviewed-by: Avri Altman <avri.altman@wdc.com>
Signed-off-by: Raul E Rangel <rrangel@chromium.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
2019-05-06 12:33:03 +02:00
..
core mmc: core: Verify SD bus width 2019-05-06 12:33:03 +02:00
host mmc: sdhci-esdhc-imx: Add HS400 support for iMX7ULP 2019-05-06 12:33:03 +02:00
Kconfig mmc: core: Remove option not to use blk-mq 2017-12-11 12:55:02 +01:00
Makefile mmc: Kconfig: downgrade CONFIG_MMC_DEBUG for host drivers only 2017-08-30 14:01:34 +02:00