mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-21 02:01:05 +07:00
71bb244ba2
This patch extends the use of the brcmfmac driver with support for chipsets with a USB host interface. The first chipsets supported are the bcm43235, bcm43236, and bcm43238 for which firmware has been submitted. This driver change has been successfully built for x86, x86_64, ppc64, arm_le, and mips_be. It has been tested successfully on x86 and x86_64. Cc: M. Lambert <lambertm@westman.wave.ca> Reviewed-by: Pieter-Paul Giesberts <pieterpg@broadcom.com> Reviewed-by: Franky (Zhenhui) Lin <frankyl@broadcom.com> Reviewed-by: Kan Yan <kanyan@broadcom.com> Reviewed-by: Alwin Beukers <alwin@broadcom.com> Signed-off-by: Arend van Spriel <arend@broadcom.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
76 lines
2.7 KiB
C
76 lines
2.7 KiB
C
/*
|
|
* Copyright (c) 2011 Broadcom Corporation
|
|
*
|
|
* Permission to use, copy, modify, and/or distribute this software for any
|
|
* purpose with or without fee is hereby granted, provided that the above
|
|
* copyright notice and this permission notice appear in all copies.
|
|
*
|
|
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
|
|
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
|
|
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY
|
|
* SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
|
|
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN ACTION
|
|
* OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF OR IN
|
|
* CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
|
|
*/
|
|
|
|
#ifndef _USB_RDL_H
|
|
#define _USB_RDL_H
|
|
|
|
/* Control messages: bRequest values */
|
|
#define DL_GETSTATE 0 /* returns the rdl_state_t struct */
|
|
#define DL_CHECK_CRC 1 /* currently unused */
|
|
#define DL_GO 2 /* execute downloaded image */
|
|
#define DL_START 3 /* initialize dl state */
|
|
#define DL_REBOOT 4 /* reboot the device in 2 seconds */
|
|
#define DL_GETVER 5 /* returns the bootrom_id_t struct */
|
|
#define DL_GO_PROTECTED 6 /* execute the downloaded code and set reset
|
|
* event to occur in 2 seconds. It is the
|
|
* responsibility of the downloaded code to
|
|
* clear this event
|
|
*/
|
|
#define DL_EXEC 7 /* jump to a supplied address */
|
|
#define DL_RESETCFG 8 /* To support single enum on dongle
|
|
* - Not used by bootloader
|
|
*/
|
|
#define DL_DEFER_RESP_OK 9 /* Potentially defer the response to setup
|
|
* if resp unavailable
|
|
*/
|
|
|
|
/* states */
|
|
#define DL_WAITING 0 /* waiting to rx first pkt */
|
|
#define DL_READY 1 /* hdr was good, waiting for more of the
|
|
* compressed image */
|
|
#define DL_BAD_HDR 2 /* hdr was corrupted */
|
|
#define DL_BAD_CRC 3 /* compressed image was corrupted */
|
|
#define DL_RUNNABLE 4 /* download was successful,waiting for go cmd */
|
|
#define DL_START_FAIL 5 /* failed to initialize correctly */
|
|
#define DL_NVRAM_TOOBIG 6 /* host specified nvram data exceeds DL_NVRAM
|
|
* value */
|
|
#define DL_IMAGE_TOOBIG 7 /* download image too big (exceeds DATA_START
|
|
* for rdl) */
|
|
|
|
struct rdl_state_le {
|
|
__le32 state;
|
|
__le32 bytes;
|
|
};
|
|
|
|
struct bootrom_id_le {
|
|
__le32 chip; /* Chip id */
|
|
__le32 chiprev; /* Chip rev */
|
|
__le32 ramsize; /* Size of RAM */
|
|
__le32 remapbase; /* Current remap base address */
|
|
__le32 boardtype; /* Type of board */
|
|
__le32 boardrev; /* Board revision */
|
|
};
|
|
|
|
#define RDL_CHUNK 1500 /* size of each dl transfer */
|
|
|
|
#define TRX_OFFSETS_DLFWLEN_IDX 0
|
|
#define TRX_OFFSETS_JUMPTO_IDX 1
|
|
#define TRX_OFFSETS_NVM_LEN_IDX 2
|
|
|
|
#define TRX_OFFSETS_DLBASE_IDX 0
|
|
|
|
#endif /* _USB_RDL_H */
|