mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-28 11:18:45 +07:00
e3b3292215
Remove the data-ready-gpio property in favor of the DT standard interrupt-parent and interrupts. Signed-off-by: Dan Murphy <dmurphy@ti.com> Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
41 lines
1.3 KiB
Plaintext
41 lines
1.3 KiB
Plaintext
Texas Instruments TCAN4x5x CAN Controller
|
|
================================================
|
|
|
|
This file provides device node information for the TCAN4x5x interface contains.
|
|
|
|
Required properties:
|
|
- compatible: "ti,tcan4x5x"
|
|
- reg: 0
|
|
- #address-cells: 1
|
|
- #size-cells: 0
|
|
- spi-max-frequency: Maximum frequency of the SPI bus the chip can
|
|
operate at should be less than or equal to 18 MHz.
|
|
- device-wake-gpios: Wake up GPIO to wake up the TCAN device.
|
|
- interrupt-parent: the phandle to the interrupt controller which provides
|
|
the interrupt.
|
|
- interrupts: interrupt specification for data-ready.
|
|
|
|
See Documentation/devicetree/bindings/net/can/m_can.txt for additional
|
|
required property details.
|
|
|
|
Optional properties:
|
|
- reset-gpios: Hardwired output GPIO. If not defined then software
|
|
reset.
|
|
- device-state-gpios: Input GPIO that indicates if the device is in
|
|
a sleep state or if the device is active.
|
|
|
|
Example:
|
|
tcan4x5x: tcan4x5x@0 {
|
|
compatible = "ti,tcan4x5x";
|
|
reg = <0>;
|
|
#address-cells = <1>;
|
|
#size-cells = <1>;
|
|
spi-max-frequency = <10000000>;
|
|
bosch,mram-cfg = <0x0 0 0 32 0 0 1 1>;
|
|
interrupt-parent = <&gpio1>;
|
|
interrupts = <14 GPIO_ACTIVE_LOW>;
|
|
device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
|
|
device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>;
|
|
reset-gpios = <&gpio1 27 GPIO_ACTIVE_LOW>;
|
|
};
|