linux_dsm_epyc7002/Documentation/devicetree/bindings/watchdog/atmel-sama5d4-wdt.txt
Eugen Hristev 74f078c333 dt-bindings: watchdog: sama5d4_wdt: add microchip,sam9x60-wdt compatible
The Atmel sama5d4_wdt needs to be compatible with microchip,sam9x60-wdt
The sama5d4_wdt driver is updated to work with both hardware blocks
(sama5d4/sama5d2 and sam9x60 based blocks)

Signed-off-by: Eugen Hristev <eugen.hristev@microchip.com>
Acked-by: Rob Herring <robh@kernel.org>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/1573806579-7981-2-git-send-email-eugen.hristev@microchip.com
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
2019-11-18 20:14:46 +01:00

35 lines
1.3 KiB
Plaintext

* Atmel SAMA5D4 Watchdog Timer (WDT) Controller
Required properties:
- compatible: "atmel,sama5d4-wdt" or "microchip,sam9x60-wdt"
- reg: base physical address and length of memory mapped region.
Optional properties:
- timeout-sec: watchdog timeout value (in seconds).
- interrupts: interrupt number to the CPU.
- atmel,watchdog-type: should be "hardware" or "software".
"hardware": enable watchdog fault reset. A watchdog fault triggers
watchdog reset.
"software": enable watchdog fault interrupt. A watchdog fault asserts
watchdog interrupt.
- atmel,idle-halt: present if you want to stop the watchdog when the CPU is
in idle state.
CAUTION: This property should be used with care, it actually makes the
watchdog not counting when the CPU is in idle state, therefore the
watchdog reset time depends on mean CPU usage and will not reset at all
if the CPU stop working while it is in idle state, which is probably
not what you want.
- atmel,dbg-halt: present if you want to stop the watchdog when the CPU is
in debug state.
Example:
watchdog@fc068640 {
compatible = "atmel,sama5d4-wdt";
reg = <0xfc068640 0x10>;
interrupts = <4 IRQ_TYPE_LEVEL_HIGH 5>;
timeout-sec = <10>;
atmel,watchdog-type = "hardware";
atmel,dbg-halt;
atmel,idle-halt;
};