Evan Nimmo 0a355aeb24 i2c: algo: pca: Reapply i2c bus settings after reset ... If something goes wrong (such as the SCL being stuck low) then we need to reset the PCA chip. The issue with this is that on reset we lose all config settings and the chip ends up in a disabled state which results in a lock up/high CPU usage. We need to re-apply any configuration that had previously been set and re-enable the chip. Signed-off-by: Evan Nimmo <evan.nimmo@alliedtelesis.co.nz> Reviewed-by: Chris Packham <chris.packham@alliedtelesis.co.nz> Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> Signed-off-by: Wolfram Sang <wsa@kernel.org>		2020-09-09 10:22:40 +02:00
..
algos
busses
muxes
i2c-boardinfo.c
i2c-core-acpi.c
i2c-core-base.c
i2c-core-of.c
i2c-core-slave.c
i2c-core-smbus.c
i2c-core.h
i2c-dev.c
i2c-mux.c
i2c-slave-eeprom.c
i2c-smbus.c
i2c-stub.c
Kconfig
Makefile