Krzysztof Kozlowski 94be46b9e5 regulator: s2mps11: Set default ramp delay for S2MPS11 LDOs ... Driver did not provide default value for ramp delay for LDOs which lead to warning in dmesg, e.g. on Odroid XU4: [ 1.486076] vdd_ldo9: ramp_delay not set [ 1.506875] vddq_mmc2: ramp_delay not set [ 1.523766] vdd_ldo15: ramp_delay not set [ 1.544702] vdd_sd: ramp_delay not set The datasheet for all the S2MPS1x family is inconsistent here and does not specify unambiguously the value of ramp delay for LDO. It mentions 30 mV/us in one timing diagram but then omits it completely in LDO regulator characteristics table (it is specified for bucks). However the vendor kernels for Galaxy S5 and Odroid XU3 use values of 12 mV/us or 24 mV/us. Without the ramp delay value the consumers do not wait for voltage settle after changing it. Although the proper value of ramp delay for LDOs is unknown, it seems safer to use at least some value from reference kernel than to leave it unset. Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com> Signed-off-by: Mark Brown <broonie@kernel.org>		2016-04-18 17:31:38 +01:00
..
abx500	power_supply: Change ownership from driver to core	2015-03-13 23:15:51 +01:00
arizona	mfd: arizona: Add device tree binding to specify mono outputs	2016-01-11 07:33:16 +00:00
da9052	mfd: da9053: Addition of extra registers for GPIOs 8-13	2015-10-30 17:19:49 +00:00
da9055	mfd: Constify regmap and irq configuration data	2015-06-22 12:25:01 +01:00
da9062	mfd: da9062: Supply core driver	2015-08-11 15:08:45 +01:00
da9063	mfd: da9063: Fix missing DA9063_M_DVC_RDY mask bit	2015-08-11 15:08:51 +01:00
da9150	mfd: da9150: Add support for Fuel-Gauge	2015-10-13 11:27:54 +01:00
mt6323	mfd: mt6397: Add MT6323 support to MT6397 driver	2016-03-16 08:50:30 +00:00
mt6397	mfd: mt6397: int_con and int_status may vary in location	2016-03-16 08:50:28 +00:00
pcf50633
samsung	regulator: s2mps11: Set default ramp delay for S2MPS11 LDOs	2016-04-18 17:31:38 +01:00
syscon	mfd: imx6sx: Add PCIe register definitions for iomuxc gpr	2016-03-16 08:50:41 +00:00
wm831x
wm8350	leds: wm8350: Remove work queue	2016-01-04 09:57:35 +01:00
wm8994
88pm80x.h	mfd: 88pm80x: Add 88pm860 chip type support	2015-10-26 14:48:56 +00:00
88pm860x.h
aat2870.h
ab3100.h
abx500.h
adp5520.h
as3711.h	mfd: as3711: Set regmap config reg counts properly	2016-03-16 08:50:34 +00:00
as3722.h
asic3.h
atmel-hlcdc.h
axp20x.h	mfd: axp20x: Add support for RSB based AXP223 PMIC	2016-02-12 08:54:42 +00:00
bcm590xx.h
core.h	mfd: core: propagate device properties to sub devices drivers	2015-12-07 02:29:23 +01:00
cros_ec_commands.h	mfd: cros_ec: rev cros_ec_commands.h	2015-06-15 13:18:20 +01:00
cros_ec.h	mfd: cros_ec: Small kerneldoc fix	2016-03-16 08:50:24 +00:00
da903x.h
davinci_voicecodec.h
db8500-prcmu.h
dbx500-prcmu.h
dln2.h
ds1wm.h
ezx-pcap.h
hi6421-pmic.h
htc-egpio.h
htc-pasic3.h
imx25-tsadc.h	mfd: fsl-imx25-tsadc: Register touchscreen ADC driver	2016-02-11 15:40:41 +00:00
intel_bxtwc.h	mfd: add Intel Broxton Whiskey Cove PMIC driver	2015-10-30 17:18:50 +00:00
intel_msic.h
intel_soc_pmic.h	mfd: intel_soc_pmic: Add support for Broxton WC PMIC	2015-10-30 17:18:03 +00:00
ipaq-micro.h
janz.h
kempld.h
lm3533.h
lp3943.h	Revert "gpio: lp3943: Drop pin_used and lp3943_gpio_request/lp3943_gpio_free"	2016-03-09 22:00:27 +07:00
lp8788-isink.h
lp8788.h
lpc_ich.h	mfd: watchdog: iTCO_wdt: Expose watchdog properties using platform data	2015-08-11 15:03:21 +01:00
max8907.h
max8925.h
max8997-private.h
max8997.h
max8998-private.h
max8998.h
max14577-private.h
max14577.h
max77686-private.h	rtc: max77686: move initialisation of rtc regmap, irq chip locally	2016-03-14 17:08:13 +01:00
max77686.h	mfd: max77686: Remove unused struct max77686_opmode_data	2015-06-22 12:25:05 +01:00
max77693-common.h	drivers: max77843: Switch to common max77693 state container	2015-07-16 21:39:30 +01:00
max77693-private.h	mfd/extcon: max77693: Rename defines to allow inclusion with max77843	2015-07-16 21:39:30 +01:00
max77693.h	== Changes to existing drivers ==	2015-04-14 17:29:55 -07:00
max77843-private.h	mfd/extcon: max77843: Rename defines to allow inclusion with max77693	2015-07-16 21:39:30 +01:00
mc13xxx.h
mc13783.h
mc13892.h
mcp.h
menelaus.h	mfd: menelaus: Drop support for SW controller VCORE	2015-03-30 10:06:50 +01:00
palmas.h	extcon: palmas: Add the support for VBUS detection by using GPIO	2016-02-05 14:15:31 +09:00
qcom_rpm.h
rc5t583.h	mfd: rc5t583: Set regmap config reg counts properly	2016-03-16 08:50:34 +00:00
rdc321x.h
retu.h
rk808.h	mfd: rk808: Disable the under voltage detect	2015-03-12 09:07:10 +00:00
rn5t618.h
rt5033-private.h
rt5033.h	power_supply: Change ownership from driver to core	2015-03-13 23:15:51 +01:00
rtsx_common.h
rtsx_pci.h	mfd: rtsx: Add support for rts522A	2015-10-30 17:19:51 +00:00
rtsx_usb.h
si476x-core.h
si476x-platform.h
si476x-reports.h
sky81452.h	mfd: Add support for Skyworks SKY81452 driver	2015-03-12 09:08:12 +00:00
smsc.h
sta2x11-mfd.h
stmpe.h	Input: stmpe-ts - enforce device tree only mode	2015-05-26 14:16:08 -07:00
stw481x.h	regulator: stw481x: Remove unused fields from struct stw481x	2015-03-21 01:05:56 +00:00
syscon.h	mfd: syscon: Return ENOTSUPP instead of ENOSYS when disabled	2016-03-16 08:50:35 +00:00
t7l66xb.h
tc3589x.h	Input: tc3589x - localize platform data	2015-04-03 17:08:59 -07:00
tc6387xb.h
tc6393xb.h
ti_am335x_tscadc.h	mfd: ti_am335x_tscadc: Remove unwanted reg_se_cache save	2015-03-03 16:41:15 +00:00
tmio.h	mmc: tmio: add flag to reduce delay after changing clock status	2016-02-29 11:03:04 +01:00
tps6105x.h	mfd: tps6105x: Use i2c regmap to access registers	2015-10-05 10:38:22 +01:00
tps6507x.h
tps6586x.h
tps65086.h	mfd: tps65086: Add driver for the TPS65086 PMIC	2016-03-16 08:50:15 +00:00
tps65090.h	mfd: tps65090: Set regmap config reg counts properly	2016-03-16 08:50:36 +00:00
tps65217.h
tps65218.h	regulator: tps65218: add support for LS3 current regulator	2015-11-25 12:25:26 +00:00
tps65910.h
tps65912.h	mfd: tps65912: Add driver for the TPS65912 PMIC	2016-02-11 16:30:59 +00:00
tps80031.h
twl4030-audio.h
twl6040.h
ucb1x00.h
viperboard.h
wl1273-core.h
wm8400-audio.h
wm8400-private.h
wm8400.h