linux_dsm_epyc7002/net/econet/Kconfig
Sam Ravnborg 6a2e9b738c [NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.

The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.

Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.

Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
2005-07-11 21:13:56 -07:00

37 lines
1.2 KiB
Plaintext

#
# Acorn Econet/AUN protocols
#
config ECONET
tristate "Acorn Econet/AUN protocols (EXPERIMENTAL)"
depends on EXPERIMENTAL && INET
---help---
Econet is a fairly old and slow networking protocol mainly used by
Acorn computers to access file and print servers. It uses native
Econet network cards. AUN is an implementation of the higher level
parts of Econet that runs over ordinary Ethernet connections, on
top of the UDP packet protocol, which in turn runs on top of the
Internet protocol IP.
If you say Y here, you can choose with the next two options whether
to send Econet/AUN traffic over a UDP Ethernet connection or over
a native Econet network card.
To compile this driver as a module, choose M here: the module
will be called econet.
config ECONET_AUNUDP
bool "AUN over UDP"
depends on ECONET
help
Say Y here if you want to send Econet/AUN traffic over a UDP
connection (UDP is a packet based protocol that runs on top of the
Internet protocol IP) using an ordinary Ethernet network card.
config ECONET_NATIVE
bool "Native Econet"
depends on ECONET
help
Say Y here if you have a native Econet network card installed in
your computer.