mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-02 17:46:45 +07:00
dd14be4c27
There is sometimes a need for the ocores driver to add devices to the bus when installed. i2c_register_board_info can not always be used, because the I2C devices are not known at an early state, they could for instance be connected on a I2C bus on a PCI device which has the Open Cores IP. i2c_new_device can not be used in all cases either since the resulting bus nummer might be unknown. The solution is the pass a list of I2C devices in the platform data to the Open Cores driver. This is useful for MFD drivers. Signed-off-by: Richard Röjfors <richard.rojfors.ext@mocean-labs.com> Signed-off-by: Ben Dooks <ben-linux@fluff.org> |
||
|---|---|---|
| .. | ||
| busses | ||
| chips | ||
| dev-interface | ||
| fault-codes | ||
| functionality | ||
| i2c-protocol | ||
| i2c-stub | ||
| instantiating-devices | ||
| smbus-protocol | ||
| summary | ||
| ten-bit-addresses | ||
| upgrading-clients | ||
| writing-clients | ||