linux_dsm_epyc7002/arch/x86/kernel/apic/apic_noop.c
Thomas Gleixner a31e58e129 x86/apic: Switch all APICs to Fixed delivery mode
Some of the APIC incarnations are operating in lowest priority delivery
mode. This worked as long as the vector management code allocated the same
vector on all possible CPUs for each interrupt.

Lowest priority delivery mode does not necessarily respect the affinity
setting and may redirect to some other online CPU. This was documented
somewhere in the old code and the conversion to single target delivery
missed to update the delivery mode of the affected APIC drivers which
results in spurious interrupts on some of the affected CPU/Chipset
combinations.

Switch the APIC drivers over to Fixed delivery mode and remove all
leftovers of lowest priority delivery mode.

Switching to Fixed delivery mode is not a problem on these CPUs because the
kernel already uses Fixed delivery mode for IPIs. The reason for this is
that th SDM explicitely forbids lowest prio mode for IPIs. The reason is
obvious: If the irq routing does not honor destination targets in lowest
prio mode then an IPI targeted at CPU1 might end up on CPU0, which would be
a fatal problem in many cases.

As a consequence of this change, the apic::irq_delivery_mode field is now
pointless, but this needs to be cleaned up in a separate patch.

Fixes: fdba46ffb4 ("x86/apic: Get rid of multi CPU affinity")
Reported-by: vcaputo@pengaru.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Tested-by: vcaputo@pengaru.com
Cc: Pavel Machek <pavel@ucw.cz>
Link: https://lkml.kernel.org/r/alpine.DEB.2.20.1712281140440.1688@nanos
2017-12-29 14:20:48 +01:00

161 lines
3.8 KiB
C

// SPDX-License-Identifier: GPL-2.0
/*
* NOOP APIC driver.
*
* Does almost nothing and should be substituted by a real apic driver via
* probe routine.
*
* Though in case if apic is disabled (for some reason) we try
* to not uglify the caller's code and allow to call (some) apic routines
* like self-ipi, etc...
*/
#include <linux/threads.h>
#include <linux/cpumask.h>
#include <linux/string.h>
#include <linux/kernel.h>
#include <linux/ctype.h>
#include <linux/errno.h>
#include <asm/fixmap.h>
#include <asm/mpspec.h>
#include <asm/apicdef.h>
#include <asm/apic.h>
#include <asm/setup.h>
#include <linux/smp.h>
#include <asm/ipi.h>
#include <linux/interrupt.h>
#include <asm/acpi.h>
#include <asm/e820/api.h>
static void noop_init_apic_ldr(void) { }
static void noop_send_IPI(int cpu, int vector) { }
static void noop_send_IPI_mask(const struct cpumask *cpumask, int vector) { }
static void noop_send_IPI_mask_allbutself(const struct cpumask *cpumask, int vector) { }
static void noop_send_IPI_allbutself(int vector) { }
static void noop_send_IPI_all(int vector) { }
static void noop_send_IPI_self(int vector) { }
static void noop_apic_wait_icr_idle(void) { }
static void noop_apic_icr_write(u32 low, u32 id) { }
static int noop_wakeup_secondary_cpu(int apicid, unsigned long start_eip)
{
return -1;
}
static u32 noop_safe_apic_wait_icr_idle(void)
{
return 0;
}
static u64 noop_apic_icr_read(void)
{
return 0;
}
static int noop_phys_pkg_id(int cpuid_apic, int index_msb)
{
return 0;
}
static unsigned int noop_get_apic_id(unsigned long x)
{
return 0;
}
static int noop_probe(void)
{
/*
* NOOP apic should not ever be
* enabled via probe routine
*/
return 0;
}
static int noop_apic_id_registered(void)
{
/*
* if we would be really "pedantic"
* we should pass read_apic_id() here
* but since NOOP suppose APIC ID = 0
* lets save a few cycles
*/
return physid_isset(0, phys_cpu_present_map);
}
static u32 noop_apic_read(u32 reg)
{
WARN_ON_ONCE(boot_cpu_has(X86_FEATURE_APIC) && !disable_apic);
return 0;
}
static void noop_apic_write(u32 reg, u32 v)
{
WARN_ON_ONCE(boot_cpu_has(X86_FEATURE_APIC) && !disable_apic);
}
#ifdef CONFIG_X86_32
static int noop_x86_32_early_logical_apicid(int cpu)
{
return BAD_APICID;
}
#endif
struct apic apic_noop __ro_after_init = {
.name = "noop",
.probe = noop_probe,
.acpi_madt_oem_check = NULL,
.apic_id_valid = default_apic_id_valid,
.apic_id_registered = noop_apic_id_registered,
.irq_delivery_mode = dest_Fixed,
/* logical delivery broadcast to all CPUs: */
.irq_dest_mode = 1,
.disable_esr = 0,
.dest_logical = APIC_DEST_LOGICAL,
.check_apicid_used = default_check_apicid_used,
.init_apic_ldr = noop_init_apic_ldr,
.ioapic_phys_id_map = default_ioapic_phys_id_map,
.setup_apic_routing = NULL,
.cpu_present_to_apicid = default_cpu_present_to_apicid,
.apicid_to_cpu_present = physid_set_mask_of_physid,
.check_phys_apicid_present = default_check_phys_apicid_present,
.phys_pkg_id = noop_phys_pkg_id,
.get_apic_id = noop_get_apic_id,
.set_apic_id = NULL,
.calc_dest_apicid = apic_flat_calc_apicid,
.send_IPI = noop_send_IPI,
.send_IPI_mask = noop_send_IPI_mask,
.send_IPI_mask_allbutself = noop_send_IPI_mask_allbutself,
.send_IPI_allbutself = noop_send_IPI_allbutself,
.send_IPI_all = noop_send_IPI_all,
.send_IPI_self = noop_send_IPI_self,
.wakeup_secondary_cpu = noop_wakeup_secondary_cpu,
.inquire_remote_apic = NULL,
.read = noop_apic_read,
.write = noop_apic_write,
.eoi_write = noop_apic_write,
.icr_read = noop_apic_icr_read,
.icr_write = noop_apic_icr_write,
.wait_icr_idle = noop_apic_wait_icr_idle,
.safe_wait_icr_idle = noop_safe_apic_wait_icr_idle,
#ifdef CONFIG_X86_32
.x86_32_early_logical_apicid = noop_x86_32_early_logical_apicid,
#endif
};