mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-27 05:29:07 +07:00
f09757ab40
The integration of the Designware SPI controller on Microsemi SoCs requires an extra register set to be able to give the IP control of the SPI interface. Cc: Rob Herring <robh+dt@kernel.org> Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com> Signed-off-by: Mark Brown <broonie@kernel.org>
33 lines
1.0 KiB
Plaintext
33 lines
1.0 KiB
Plaintext
Synopsys DesignWare AMBA 2.0 Synchronous Serial Interface.
|
|
|
|
Required properties:
|
|
- compatible : "snps,dw-apb-ssi" or "mscc,<soc>-spi", where soc is "ocelot" or
|
|
"jaguar2"
|
|
- reg : The register base for the controller. For "mscc,<soc>-spi", a second
|
|
register set is required (named ICPU_CFG:SPI_MST)
|
|
- interrupts : One interrupt, used by the controller.
|
|
- #address-cells : <1>, as required by generic SPI binding.
|
|
- #size-cells : <0>, also as required by generic SPI binding.
|
|
|
|
Optional properties:
|
|
- cs-gpios : Specifies the gpio pis to be used for chipselects.
|
|
- num-cs : The number of chipselects. If omitted, this will default to 4.
|
|
- reg-io-width : The I/O register width (in bytes) implemented by this
|
|
device. Supported values are 2 or 4 (the default).
|
|
|
|
Child nodes as per the generic SPI binding.
|
|
|
|
Example:
|
|
|
|
spi@fff00000 {
|
|
compatible = "snps,dw-apb-ssi";
|
|
reg = <0xfff00000 0x1000>;
|
|
interrupts = <0 154 4>;
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
num-cs = <2>;
|
|
cs-gpios = <&gpio0 13 0>,
|
|
<&gpio0 14 0>;
|
|
};
|
|
|