AuxXxilium/linux_dsm_epyc7002
1
0
Fork 0
mirror of https://github.com/AuxXxilium/linux_dsm_epyc7002.git synced 2024-12-21 14:09:55 +07:00
Code Issues Actions Packages Projects Releases Wiki Activity
7890b9701b
linux_dsm_epyc7002/drivers/media/cec/cec-pin-priv.h
Hans Verkuil 6ec1cbf6b1 media: cec: improve CEC pin event handling 
It turns out that the struct cec_fh event buffer size of 64 events
(64 for CEC_EVENT_PIN_CEC_LOW and 64 for _HIGH) is too small. It's
about 160 ms worth of events and if the Raspberry Pi is busy, then it
might take too long for the application to be scheduled so that it can
drain the pending events. Increase these buffers to 800 events which
is at least 2 seconds worth of events.

There is also a FIFO in between the interrupt and the cec-pin thread.
The thread passes the events on to the CEC core. It is important that
should this FIFO fill up the cec core will be informed that events
have been lost so this can be communicated to the user by setting
CEC_EVENT_FL_DROPPED_EVENTS.

It is very hard to debug CEC problems if events were lost without
informing the user of that fact.

If events were dropped due to the FIFO filling up, then the debugfs
status file will let you know how many events were dropped.

Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>
2018-03-22 08:16:52 -04:00

242 lines
7.4 KiB
C
Raw Blame History

/* SPDX-License-Identifier: GPL-2.0-only */
/*
* cec-pin-priv.h - internal cec-pin header
*
* Copyright 2017 Cisco Systems, Inc. and/or its affiliates. All rights reserved.
*/
#ifndef LINUX_CEC_PIN_PRIV_H
#define LINUX_CEC_PIN_PRIV_H
#include <linux/types.h>
#include <linux/atomic.h>
#include <media/cec-pin.h>
enum cec_pin_state {
/* CEC is off */
CEC_ST_OFF,
/* CEC is idle, waiting for Rx or Tx */
CEC_ST_IDLE,
/* Tx states */
/* Pending Tx, waiting for Signal Free Time to expire */
CEC_ST_TX_WAIT,
/* Low-drive was detected, wait for bus to go high */
CEC_ST_TX_WAIT_FOR_HIGH,
/* Drive CEC low for the start bit */
CEC_ST_TX_START_BIT_LOW,
/* Drive CEC high for the start bit */
CEC_ST_TX_START_BIT_HIGH,
/* Generate a start bit period that is too short */
CEC_ST_TX_START_BIT_HIGH_SHORT,
/* Generate a start bit period that is too long */
CEC_ST_TX_START_BIT_HIGH_LONG,
/* Drive CEC low for the start bit using the custom timing */
CEC_ST_TX_START_BIT_LOW_CUSTOM,
/* Drive CEC high for the start bit using the custom timing */
CEC_ST_TX_START_BIT_HIGH_CUSTOM,
/* Drive CEC low for the 0 bit */
CEC_ST_TX_DATA_BIT_0_LOW,
/* Drive CEC high for the 0 bit */
CEC_ST_TX_DATA_BIT_0_HIGH,
/* Generate a bit period that is too short */
CEC_ST_TX_DATA_BIT_0_HIGH_SHORT,
/* Generate a bit period that is too long */
CEC_ST_TX_DATA_BIT_0_HIGH_LONG,
/* Drive CEC low for the 1 bit */
CEC_ST_TX_DATA_BIT_1_LOW,
/* Drive CEC high for the 1 bit */
CEC_ST_TX_DATA_BIT_1_HIGH,
/* Generate a bit period that is too short */
CEC_ST_TX_DATA_BIT_1_HIGH_SHORT,
/* Generate a bit period that is too long */
CEC_ST_TX_DATA_BIT_1_HIGH_LONG,
/*
* Wait for start of sample time to check for Ack bit or first
* four initiator bits to check for Arbitration Lost.
*/
CEC_ST_TX_DATA_BIT_1_HIGH_PRE_SAMPLE,
/* Wait for end of bit period after sampling */
CEC_ST_TX_DATA_BIT_1_HIGH_POST_SAMPLE,
/* Generate a bit period that is too short */
CEC_ST_TX_DATA_BIT_1_HIGH_POST_SAMPLE_SHORT,
/* Generate a bit period that is too long */
CEC_ST_TX_DATA_BIT_1_HIGH_POST_SAMPLE_LONG,
/* Drive CEC low for a data bit using the custom timing */
CEC_ST_TX_DATA_BIT_LOW_CUSTOM,
/* Drive CEC high for a data bit using the custom timing */
CEC_ST_TX_DATA_BIT_HIGH_CUSTOM,
/* Drive CEC low for a standalone pulse using the custom timing */
CEC_ST_TX_PULSE_LOW_CUSTOM,
/* Drive CEC high for a standalone pulse using the custom timing */
CEC_ST_TX_PULSE_HIGH_CUSTOM,
/* Start low drive */
CEC_ST_TX_LOW_DRIVE,
/* Rx states */
/* Start bit low detected */
CEC_ST_RX_START_BIT_LOW,
/* Start bit high detected */
CEC_ST_RX_START_BIT_HIGH,
/* Wait for bit sample time */
CEC_ST_RX_DATA_SAMPLE,
/* Wait for earliest end of bit period after sampling */
CEC_ST_RX_DATA_POST_SAMPLE,
/* Wait for CEC to go low (i.e. end of bit period) */
CEC_ST_RX_DATA_WAIT_FOR_LOW,
/* Drive CEC low to send 0 Ack bit */
CEC_ST_RX_ACK_LOW,
/* End of 0 Ack time, wait for earliest end of bit period */
CEC_ST_RX_ACK_LOW_POST,
/* Wait for CEC to go high (i.e. end of bit period */
CEC_ST_RX_ACK_HIGH_POST,
/* Wait for earliest end of bit period and end of message */
CEC_ST_RX_ACK_FINISH,
/* Start low drive */
CEC_ST_RX_LOW_DRIVE,
/* Monitor pin using interrupts */
CEC_ST_RX_IRQ,
/* Total number of pin states */
CEC_PIN_STATES
};
/* Error Injection */
/* Error injection modes */
#define CEC_ERROR_INJ_MODE_OFF 0
#define CEC_ERROR_INJ_MODE_ONCE 1
#define CEC_ERROR_INJ_MODE_ALWAYS 2
#define CEC_ERROR_INJ_MODE_TOGGLE 3
#define CEC_ERROR_INJ_MODE_MASK 3ULL
/* Receive error injection options */
#define CEC_ERROR_INJ_RX_NACK_OFFSET 0
#define CEC_ERROR_INJ_RX_LOW_DRIVE_OFFSET 2
#define CEC_ERROR_INJ_RX_ADD_BYTE_OFFSET 4
#define CEC_ERROR_INJ_RX_REMOVE_BYTE_OFFSET 6
#define CEC_ERROR_INJ_RX_ARB_LOST_OFFSET 8
#define CEC_ERROR_INJ_RX_MASK 0xffffULL
/* Transmit error injection options */
#define CEC_ERROR_INJ_TX_NO_EOM_OFFSET 16
#define CEC_ERROR_INJ_TX_EARLY_EOM_OFFSET 18
#define CEC_ERROR_INJ_TX_SHORT_BIT_OFFSET 20
#define CEC_ERROR_INJ_TX_LONG_BIT_OFFSET 22
#define CEC_ERROR_INJ_TX_CUSTOM_BIT_OFFSET 24
#define CEC_ERROR_INJ_TX_SHORT_START_OFFSET 26
#define CEC_ERROR_INJ_TX_LONG_START_OFFSET 28
#define CEC_ERROR_INJ_TX_CUSTOM_START_OFFSET 30
#define CEC_ERROR_INJ_TX_LAST_BIT_OFFSET 32
#define CEC_ERROR_INJ_TX_ADD_BYTES_OFFSET 34
#define CEC_ERROR_INJ_TX_REMOVE_BYTE_OFFSET 36
#define CEC_ERROR_INJ_TX_LOW_DRIVE_OFFSET 38
#define CEC_ERROR_INJ_TX_MASK 0xffffffffffff0000ULL
#define CEC_ERROR_INJ_RX_LOW_DRIVE_ARG_IDX 0
#define CEC_ERROR_INJ_RX_ARB_LOST_ARG_IDX 1
#define CEC_ERROR_INJ_TX_ADD_BYTES_ARG_IDX 2
#define CEC_ERROR_INJ_TX_SHORT_BIT_ARG_IDX 3
#define CEC_ERROR_INJ_TX_LONG_BIT_ARG_IDX 4
#define CEC_ERROR_INJ_TX_CUSTOM_BIT_ARG_IDX 5
#define CEC_ERROR_INJ_TX_LAST_BIT_ARG_IDX 6
#define CEC_ERROR_INJ_TX_LOW_DRIVE_ARG_IDX 7
#define CEC_ERROR_INJ_NUM_ARGS 8
/* Special CEC op values */
#define CEC_ERROR_INJ_OP_ANY 0x00000100
/* The default for the low/high time of the custom pulse */
#define CEC_TIM_CUSTOM_DEFAULT 1000
#define CEC_NUM_PIN_EVENTS 128
#define CEC_PIN_EVENT_FL_IS_HIGH (1 << 0)
#define CEC_PIN_EVENT_FL_DROPPED (1 << 1)
#define CEC_PIN_IRQ_UNCHANGED 0
#define CEC_PIN_IRQ_DISABLE 1
#define CEC_PIN_IRQ_ENABLE 2
struct cec_pin {
struct cec_adapter *adap;
const struct cec_pin_ops *ops;
struct task_struct *kthread;
wait_queue_head_t kthread_waitq;
struct hrtimer timer;
ktime_t ts;
unsigned int wait_usecs;
u16 la_mask;
bool enabled;
bool monitor_all;
bool rx_eom;
bool enable_irq_failed;
enum cec_pin_state state;
struct cec_msg tx_msg;
u32 tx_bit;
bool tx_nacked;
u32 tx_signal_free_time;
bool tx_toggle;
struct cec_msg rx_msg;
u32 rx_bit;
bool rx_toggle;
u32 rx_start_bit_low_too_short_cnt;
u64 rx_start_bit_low_too_short_ts;
u32 rx_start_bit_low_too_short_delta;
u32 rx_start_bit_too_short_cnt;
u64 rx_start_bit_too_short_ts;
u32 rx_start_bit_too_short_delta;
u32 rx_start_bit_too_long_cnt;
u32 rx_data_bit_too_short_cnt;
u64 rx_data_bit_too_short_ts;
u32 rx_data_bit_too_short_delta;
u32 rx_data_bit_too_long_cnt;
u32 rx_low_drive_cnt;
struct cec_msg work_rx_msg;
u8 work_tx_status;
ktime_t work_tx_ts;
atomic_t work_irq_change;
atomic_t work_pin_num_events;
unsigned int work_pin_events_wr;
unsigned int work_pin_events_rd;
ktime_t work_pin_ts[CEC_NUM_PIN_EVENTS];
u8 work_pin_events[CEC_NUM_PIN_EVENTS];
bool work_pin_events_dropped;
u32 work_pin_events_dropped_cnt;
ktime_t timer_ts;
u32 timer_cnt;
u32 timer_100ms_overruns;
u32 timer_300ms_overruns;
u32 timer_max_overrun;
u32 timer_sum_overrun;
u32 tx_custom_low_usecs;
u32 tx_custom_high_usecs;
bool tx_ignore_nack_until_eom;
bool tx_custom_pulse;
bool tx_generated_poll;
bool tx_post_eom;
u8 tx_extra_bytes;
u32 tx_low_drive_cnt;
#ifdef CONFIG_CEC_PIN_ERROR_INJ
u64 error_inj[CEC_ERROR_INJ_OP_ANY + 1];
u8 error_inj_args[CEC_ERROR_INJ_OP_ANY + 1][CEC_ERROR_INJ_NUM_ARGS];
#endif
};
void cec_pin_start_timer(struct cec_pin *pin);
#ifdef CONFIG_CEC_PIN_ERROR_INJ
bool cec_pin_error_inj_parse_line(struct cec_adapter *adap, char *line);
int cec_pin_error_inj_show(struct cec_adapter *adap, struct seq_file *sf);
u16 cec_pin_rx_error_inj(struct cec_pin *pin);
u16 cec_pin_tx_error_inj(struct cec_pin *pin);
#endif
#endif
Reference in New Issue View Git Blame Copy Permalink