mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-06 04:16:39 +07:00
5c113b5e00
The DHT22 (AM2302) datasheet specifies that the LOW start pulse should not exceed 20ms. However, observations with an oscilloscope of an RPi Model 2B (rev 1.1) communicating with a DHT22 sensor showed that the driver was consistently sending start pulses longer than 20ms: Kernel 4.7.10-v7+ (n=132): Minimum pulse length: 20.20ms Maximum: 29.84ms Mean: 24.96ms StDev: 2.82ms Sensor response rate: 100% Read success rate: 76% On kernel 4.8, the start pulse was so long that the sensor would not even respond 97% of the time: Kernel 4.8.16-v7+ (n=100): Minimum pulse length: 30.4ms Maximum: 74.4ms Mean: 39.3ms StDev: 10.2ms Sensor response rate: 3% Read success rate: 3% The driver would return ETIMEDOUT and write log messages like this: [ 51.430987] dht11 dht11@0: Only 1 signal edges detected [ 66.311019] dht11 dht11@0: Only 0 signal edges detected Replacing msleep(18) with usleep_range(18000, 20000) made the pulse length sane again and restored responsiveness: Kernel 4.8.16-v7+ with usleep_range (n=123): Minimum pulse length: 18.16ms Maximum: 20.20ms Mean: 19.85ms StDev: 0.51ms Sensor response rate: 100% Read success rate: 84% Cc: stable@vger.kernel.org Signed-off-by: John Brooks <john@fastquake.com> Reviewed-by: Harald Geyer <harald@ccbib.org> Signed-off-by: Jonathan Cameron <jic23@kernel.org> |
||
---|---|---|
.. | ||
am2315.c | ||
dht11.c | ||
hdc100x.c | ||
hts221_buffer.c | ||
hts221_core.c | ||
hts221_i2c.c | ||
hts221_spi.c | ||
hts221.h | ||
htu21.c | ||
Kconfig | ||
Makefile | ||
si7005.c | ||
si7020.c |