mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-26 14:55:15 +07:00
6e053d6c79
When i2400m_bootrom_init() fails to put the device into a state of being ready to accept firmware, the driver was currently trying to reset it if it failed to do so. This is not too useful; as part of trying to put the device in the right state a few resets have already been tried. At this point, things are probably fried out and an extra reset might do more harm than good (for example causing reseting of other functions in the same composite device). So it is left up to the callers to determine the error path to take (at the end this is always i2400m_setup(), who depending on how many retries are left, might give up on the device). From a fix by Cindy H. Kao. Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com> |
||
|---|---|---|
| .. | ||
| control.c | ||
| debug-levels.h | ||
| debugfs.c | ||
| driver.c | ||
| fw.c | ||
| i2400m-sdio.h | ||
| i2400m-usb.h | ||
| i2400m.h | ||
| Kconfig | ||
| Makefile | ||
| netdev.c | ||
| op-rfkill.c | ||
| rx.c | ||
| sdio-debug-levels.h | ||
| sdio-fw.c | ||
| sdio-rx.c | ||
| sdio-tx.c | ||
| sdio.c | ||
| sysfs.c | ||
| tx.c | ||
| usb-debug-levels.h | ||
| usb-fw.c | ||
| usb-notif.c | ||
| usb-rx.c | ||
| usb-tx.c | ||
| usb.c | ||