mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-11-26 03:40:55 +07:00
5ac2469769
There are three flags being set by default by the PIIX driver for speeds >
PIO 1, and one not being cleared properly on fallback to PIO0. The most
important one is the prefetch/post write control which only works for ATA
and can do bad things with ATAPI.
The patch does its best to set the flags correctly for drivers/ide. Its
not 100% perfect but its closer than the original. 100% perfect requires
proper IORDY handling but this isn't critical (and its not right in libata
either .. yet)
Sergei Shtylyov <sshtylyov@ru.mvista.com> said:
> + { 0, 0 },
> + { 0, 0 },
> + { 1, 0 },
> + { 2, 1 },
> + { 2, 3 }, };
>
> pio = ide_get_best_pio_mode(drive, pio, 5, NULL);
BTW, there's quite obvious error here which leads to access outside of
timings[] if somebody passes PIO mode 5 (or autotuning code finds out that
drive supports PIO mode 5). Could have been fixed while at it... Those drives
should be rare, though...
> + }
> master_data = master_data | (timings[pio][0] << 12) | (timings[pio][1] << 8);
> }
> pci_write_config_word(dev, master_port, master_data);
Actually, there's one more serious issue with piix_tune_drive() -- it
doesn't actually set the drive's own transfer mode.
Signed-off-by: Alan Cox <alan@redhat.com>
Cc: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Cc: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
|
||
|---|---|---|
| .. | ||
| arm | ||
| cris | ||
| h8300 | ||
| legacy | ||
| mips | ||
| pci | ||
| ppc | ||
| ide-cd.c | ||
| ide-cd.h | ||
| ide-disk.c | ||
| ide-dma.c | ||
| ide-floppy.c | ||
| ide-generic.c | ||
| ide-io.c | ||
| ide-iops.c | ||
| ide-lib.c | ||
| ide-pnp.c | ||
| ide-probe.c | ||
| ide-proc.c | ||
| ide-tape.c | ||
| ide-taskfile.c | ||
| ide-timing.h | ||
| ide.c | ||
| Kconfig | ||
| Makefile | ||
| setup-pci.c | ||