mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2025-02-10 11:25:12 +07:00
4dc926d3a5
Currently if the iavf is loaded and a VF link transitions from up to down to up again a Tx timeout will be triggered. This happens because Tx/Rx queue interrupts are only enabled when receiving the VIRTCHNL_OP_CONFIG_MAP_IRQ message, which happens on reset or initial iavf driver load, but not when bringing link up. This is problematic because they are disabled on the VIRTCHNL_OP_DISABLE_QUEUES message, which is part of bringing a VF's link down. However, they are not enabled on the VIRTCHNL_OP_ENABLE_QUEUES message, which is part of bringing a VF's link up. Fix this by re-enabling the VF's Rx and Tx queue interrupts when they were previously configured. This is done by first checking to make sure the previous value in QINT_[R|T]QCTL.MSIX_INDX is not 0, which is used to represent the OICR in the VF's interrupt space. If the MSIX_INDX is non-zero then enable the interrupt by setting the QINT_[R|T]CTL.CAUSE_ENA bit to 1. Signed-off-by: Brett Creeley <brett.creeley@intel.com> Tested-by: Andrew Bowers <andrewx.bowers@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> |
||
|---|---|---|
| .. | ||
| e1000 | ||
| e1000e | ||
| fm10k | ||
| i40e | ||
| iavf | ||
| ice | ||
| igb | ||
| igbvf | ||
| igc | ||
| ixgb | ||
| ixgbe | ||
| ixgbevf | ||
| e100.c | ||
| Kconfig | ||
| Makefile | ||