linux_dsm_epyc7002/arch/arm/plat-mxc/Makefile
Yong Shen 64f102b67f cpufreq for freescale mx51
Currently, only two operating points: 160Mhz and 800Mhz.
the operating points are tested on babbage 3.0

Signed-off-by: Yong Shen <yong.shen@linaro.org>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
2010-10-22 08:24:14 +02:00

28 lines
782 B
Makefile

#
# Makefile for the linux kernel.
#
# Common support
obj-y := irq.o clock.o gpio.o time.o devices.o cpu.o system.o
# MX51 uses the TZIC interrupt controller, older platforms use AVIC (irq.o)
obj-$(CONFIG_MXC_TZIC) += tzic.o
obj-$(CONFIG_IMX_HAVE_IOMUX_V1) += iomux-v1.o
obj-$(CONFIG_ARCH_MXC_IOMUX_V3) += iomux-v3.o
obj-$(CONFIG_IRAM_ALLOC) += iram_alloc.o
obj-$(CONFIG_MXC_PWM) += pwm.o
obj-$(CONFIG_USB_EHCI_MXC) += ehci.o
obj-$(CONFIG_MXC_ULPI) += ulpi.o
obj-$(CONFIG_MXC_USE_EPIT) += epit.o
obj-$(CONFIG_ARCH_MXC_AUDMUX_V1) += audmux-v1.o
obj-$(CONFIG_ARCH_MXC_AUDMUX_V2) += audmux-v2.o
obj-$(CONFIG_MXC_DEBUG_BOARD) += 3ds_debugboard.o
obj-$(CONFIG_CPU_FREQ_IMX) += cpufreq.o
ifdef CONFIG_SND_IMX_SOC
obj-y += ssi-fiq.o
obj-y += ssi-fiq-ksym.o
endif
obj-y += devices/