mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-11-25 09:40:53 +07:00
25e11ec4fe
This patch removes the depends on USB from all config symbols in drivers/usb/host/Kconfig and replace that with an if USB / endif block as suggested by Alan Stern. Some source ... Kconfig lines have been shuffled around to permit a better regroupment of the Kconfig files depending on "config USB" item. No functionnal change is introduced. Acked-by: Alan Stern <stern@rowland.harvard.edu> Signed-off-by: Florian Fainelli <florian@openwrt.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
29 lines
1014 B
Plaintext
29 lines
1014 B
Plaintext
#
|
|
# USB Imaging devices configuration
|
|
#
|
|
comment "USB Imaging devices"
|
|
|
|
config USB_MDC800
|
|
tristate "USB Mustek MDC800 Digital Camera support"
|
|
---help---
|
|
Say Y here if you want to connect this type of still camera to
|
|
your computer's USB port. This driver can be used with gphoto 0.4.3
|
|
and higher (look at <http://www.gphoto.org/>).
|
|
To use it create a device node with "mknod /dev/mustek c 180 32" and
|
|
configure it in your software.
|
|
|
|
To compile this driver as a module, choose M here: the
|
|
module will be called mdc800.
|
|
|
|
config USB_MICROTEK
|
|
tristate "Microtek X6USB scanner support"
|
|
depends on SCSI
|
|
help
|
|
Say Y here if you want support for the Microtek X6USB and
|
|
possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L.
|
|
Support for anything but the X6 is experimental.
|
|
Please report failures and successes.
|
|
The scanner will appear as a scsi generic device to the rest
|
|
of the system. Scsi support is required.
|
|
This driver can be compiled as a module, called microtek.
|