mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-21 11:09:29 +07:00
d4584bbfcf
Add driver for serial-connected Mediatek-based GNSS receivers. These devices typically boot transmitting vendor specific NMEA output sequences. The serial port bit rate is read from the device tree "current-speed". Note that the driver uses the generic GNSS serial implementation and therefore essentially only manages power abstracted into three power states: ACTIVE, STANDBY, and OFF. For mediatek receivers with a main supply and no enable-gpios, this simply means that the main supply is disabled in STANDBY and OFF (the optional backup supply is kept enabled while the driver is bound). Note that the timepulse-support is left unimplemented. Signed-off-by: Loys Ollivier <lollivier@baylibre.com> [ johan: rename backup supply ] Signed-off-by: Johan Hovold <johan@kernel.org>
57 lines
1.2 KiB
Plaintext
57 lines
1.2 KiB
Plaintext
#
|
|
# GNSS receiver configuration
|
|
#
|
|
|
|
menuconfig GNSS
|
|
tristate "GNSS receiver support"
|
|
---help---
|
|
Say Y here if you have a GNSS receiver (e.g. a GPS receiver).
|
|
|
|
To compile this driver as a module, choose M here: the module will
|
|
be called gnss.
|
|
|
|
if GNSS
|
|
|
|
config GNSS_SERIAL
|
|
tristate
|
|
|
|
config GNSS_MTK_SERIAL
|
|
tristate "Mediatek GNSS receiver support"
|
|
depends on SERIAL_DEV_BUS
|
|
select GNSS_SERIAL
|
|
help
|
|
Say Y here if you have a Mediatek-based GNSS receiver which uses a
|
|
serial interface.
|
|
|
|
To compile this driver as a module, choose M here: the module will
|
|
be called gnss-mtk.
|
|
|
|
If unsure, say N.
|
|
|
|
config GNSS_SIRF_SERIAL
|
|
tristate "SiRFstar GNSS receiver support"
|
|
depends on SERIAL_DEV_BUS
|
|
---help---
|
|
Say Y here if you have a SiRFstar-based GNSS receiver which uses a
|
|
serial interface.
|
|
|
|
To compile this driver as a module, choose M here: the module will
|
|
be called gnss-sirf.
|
|
|
|
If unsure, say N.
|
|
|
|
config GNSS_UBX_SERIAL
|
|
tristate "u-blox GNSS receiver support"
|
|
depends on SERIAL_DEV_BUS
|
|
select GNSS_SERIAL
|
|
---help---
|
|
Say Y here if you have a u-blox GNSS receiver which uses a serial
|
|
interface.
|
|
|
|
To compile this driver as a module, choose M here: the module will
|
|
be called gnss-ubx.
|
|
|
|
If unsure, say N.
|
|
|
|
endif # GNSS
|