mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-27 02:25:20 +07:00
f624ec70b4
Add support for the SuperSpeed Link Layer test case TD.7.34 which requires the operator to place the port into compliance mode, and to subsequently bring it out via reset. Historically according to the (now deprecated) USB 3.0 specification a SuperSpeed host downstream port would automatically transition to Compliance mode from the Polling state if LFPS polling times out. However the language in USB 3.1 as well as xHCI 1.1 states it may be required to explicitly enable this transition. For such hosts this is done by sending a SET_FEATURE(PORT_LINK_STATE) with the state set to Compliance to the root hub port. Similar to the other supported commands, to do this via sysfs: echo > /sys/bus/usb/devices/2-0\:1.0/enable_compliance According to xHCI 1.1 section 4.19.1.2.4.1, this enables the transition to compliance mode upon LFPS timeout. Note that this can only be issued when the port is in disconnected state. And in order to disable this behavior on subsequent transitions, a warm reset should be issued. So add another entry to do that: echo > /sys/bus/usb/devices/2-0\:1.0/warm_reset In general these attributes can also be useful for other USB SuperSpeed compliance tests such as electrical and eye diagram testing which require CPn patterns to be transmitted. Signed-off-by: Jack Pham <jackp@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org> |
||
---|---|---|
.. | ||
sisusbvga | ||
adutux.c | ||
appledisplay.c | ||
chaoskey.c | ||
cypress_cy7c63.c | ||
cytherm.c | ||
ehset.c | ||
emi26.c | ||
emi62.c | ||
ezusb.c | ||
ftdi-elan.c | ||
idmouse.c | ||
iowarrior.c | ||
isight_firmware.c | ||
Kconfig | ||
ldusb.c | ||
legousbtower.c | ||
lvstest.c | ||
Makefile | ||
rio500_usb.h | ||
rio500.c | ||
trancevibrator.c | ||
usb251xb.c | ||
usb3503.c | ||
usb4604.c | ||
usb_u132.h | ||
usblcd.c | ||
usbsevseg.c | ||
usbtest.c | ||
uss720.c | ||
yurex.c |