hayeswang 1a9646497b r8169: adjust the flow of hw_start ... The suggestion as following: - initial settings or default settings - rtl_hw_start_xxx. rtl_hw_start_xxx may change some default settings. - enable tx/rx. This has to be after the above two steps. - rtl_set_rx_mode. AcceptXXXs have to be enabled after enabling tx/rx. Signed-off-by: Hayes Wang <hayeswang@realtek.com> Signed-off-by: David S. Miller <davem@davemloft.net>		2013-04-07 16:44:13 -04:00
..
8139cp.c	remove init of dev->perm_addr in drivers	2013-01-08 18:00:48 -08:00
8139too.c	drivers:net: Remove unnecessary OOM messages after netdev_alloc_skb	2013-03-09 16:09:19 -05:00
atp.c	drivers:net: Remove unnecessary OOM messages after netdev_alloc_skb	2013-03-09 16:09:19 -05:00
atp.h	atp: remove set_rx_mode_8012()	2012-11-03 15:43:04 -04:00
Kconfig	drivers/net/ethernet/realtek: remove depends on CONFIG_EXPERIMENTAL	2013-01-11 11:38:40 -08:00
Makefile	net/ethernet: sc92031 is not Realtek	2011-11-01 19:30:38 -04:00
r8169.c	r8169: adjust the flow of hw_start	2013-04-07 16:44:13 -04:00