Lars-Peter Clausen b92af2b884 ASoC: s6105-ipcam: Convert to table based DAPM setup ... Use table based setup to register the DAPM widgets and routes. This on one hand makes the code a bit shorter and cleaner and on the other hand the board level DAPM elements get registered in the card's DAPM context rather than in the CODEC's DAPM context. While we are at it also remove the snd_soc_dapm_enable_pin() in the init callback, since pins are enabled by default. Also drop the snd_soc_dapm_sync() calls, since they are ignored by the core anyway until the card has been fully instantiated. Signed-off-by: Lars-Peter Clausen <lars@metafoo.de> Signed-off-by: Mark Brown <broonie@linaro.org>		2014-03-13 11:43:30 +00:00
..
Kconfig	ASoC: s6105 IP camera machine specific ASoC code	2009-04-04 15:29:01 +01:00
Makefile	ASoC: s6105 IP camera machine specific ASoC code	2009-04-04 15:29:01 +01:00
s6000-i2s.c	ASoC: s6000: Don't mix SNDRV_PCM_RATE_CONTINUOUS with specific rates	2014-01-14 20:42:29 +00:00
s6000-i2s.h	ASoC: multi-component - ASoC Multi-Component Support	2010-08-12 14:00:00 +01:00
s6000-pcm.c	ASoC: s6000: Don't set unused struct snd_pcm_hardware fields	2013-12-24 12:02:21 +00:00
s6000-pcm.h	ASoC: multi-component - ASoC Multi-Component Support	2010-08-12 14:00:00 +01:00
s6105-ipcam.c	ASoC: s6105-ipcam: Convert to table based DAPM setup	2014-03-13 11:43:30 +00:00