mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-19 12:46:53 +07:00
1382993f88
When hardware rfkill is enabled in the firmware it will report the capability via using WMI_TLV_SYS_CAP_INFO_RFKILL bit in the WMI_SERVICE_READY event to the host. ath10k will check the capability, and if it is enabled then ath10k will set the GPIO information to firmware using WMI_PDEV_SET_PARAM. When the firmware detects hardware rfkill is enabled by the user, it will report it via WMI_RFKILL_STATE_CHANGE_EVENTID. Once ath10k receives the event it will send wmi command WMI_PDEV_SET_PARAM to the firmware to enable/disable the radio and also notifies cfg80211. We can't power off the device when rfkill is enabled, as otherwise the firmware would not be able to detect GPIO changes and report them to the host. So when rfkill is enabled, we need to keep the firmware running. Tested with QCA6174 PCI with firmware WLAN.RM.4.4.1-00109-QCARMSWPZ-1. Signed-off-by: Alan Liu <alanliu@codeaurora.org> Signed-off-by: Wen Gong <wgong@codeaurora.org> Signed-off-by: Kalle Valo <kvalo@codeaurora.org> |
||
|---|---|---|
| .. | ||
| admtek | ||
| ath | ||
| atmel | ||
| broadcom | ||
| cisco | ||
| intel | ||
| intersil | ||
| marvell | ||
| mediatek | ||
| quantenna | ||
| ralink | ||
| realtek | ||
| rsi | ||
| st | ||
| ti | ||
| zydas | ||
| Kconfig | ||
| mac80211_hwsim.c | ||
| mac80211_hwsim.h | ||
| Makefile | ||
| ray_cs.c | ||
| ray_cs.h | ||
| rayctl.h | ||
| rndis_wlan.c | ||
| virt_wifi.c | ||
| wl3501_cs.c | ||
| wl3501.h | ||