mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-28 11:18:45 +07:00
0f978bfaf2
The Buffalo device WZR-HP-G450H uses the index 3 for TX gain, which is set to the high_power table currently. Later variants of the router use the same index, but instead refer to the low_ob_db gain table. This is not handled in the driver since there is no way to distinguish board revisions and the high_power table is used (incorrectly) for the newer variants. By default, devices based on AR9300 using the TX gain index 3 have to use the high_power table. To make sure that WZR-HP-G450H is not broken when the high_power table is updated, use a separate array based on information obtained from the platform data. The current situation where only the original variant of WZR-HP-G450H works properly stays unchanged. Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com> Signed-off-by: John W. Linville <linville@tuxdriver.com> |
||
|---|---|---|
| .. | ||
| ar5523 | ||
| ath5k | ||
| ath6kl | ||
| ath9k | ||
| ath10k | ||
| carl9170 | ||
| wcn36xx | ||
| wil6210 | ||
| ath.h | ||
| debug.c | ||
| dfs_pattern_detector.c | ||
| dfs_pattern_detector.h | ||
| dfs_pri_detector.c | ||
| dfs_pri_detector.h | ||
| hw.c | ||
| Kconfig | ||
| key.c | ||
| main.c | ||
| Makefile | ||
| reg.h | ||
| regd_common.h | ||
| regd.c | ||
| regd.h | ||