Mitch Williams 40746eb14c i40evf: don't configure unused RSS queues ... The driver will only configure as many queues as there are available CPUs, up the maximum number of queues. However, it always configures RSS as though it is using the maximum number of queues. This can cause the device to drop a lot of RX traffic, as the packets get assigned to nonfunctional queues. Fix this by only configuring RSS with the number of active queues. Signed-off-by: Mitch Williams <mitch.a.williams@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>		2015-06-26 02:52:27 -07:00
..
e1000	e1000: Replace e1000_free_frag with skb_free_frag	2015-05-12 10:39:27 -04:00
e1000e	e1000e: i219 - k1 workaround for LPT is not required for SPT	2015-06-26 02:47:37 -07:00
fm10k	fm10k: Fix missing braces after if statement	2015-06-17 14:21:41 -07:00
i40e	switchdev; add VLAN support for port's bridge_getlink	2015-06-23 06:56:18 -07:00
i40evf	i40evf: don't configure unused RSS queues	2015-06-26 02:52:27 -07:00
igb	igb: bump version of igb to 5.2.18	2015-06-26 02:36:38 -07:00
igbvf	igbvf: use netif_carrier_off earlier when bringing if down	2015-03-20 17:45:12 -07:00
ixgb	ixgb: call netif_carrier_off early on down	2015-03-20 17:41:52 -07:00
ixgbe	switchdev; add VLAN support for port's bridge_getlink	2015-06-23 06:56:18 -07:00
ixgbevf	ixgbevf: Use dev_kfree_skb_any in xmit path, not dev_kfree_skb	2015-05-04 00:06:55 -04:00
e100.c	ethernet/intel: Use setup_timer	2015-05-31 21:46:01 -07:00
Kconfig	drivers/net: remove all references to obsolete Ethernet-HOWTO	2015-06-23 06:50:35 -07:00
Makefile	fm10k: Add skeletal frame for Intel(R) FM10000 Ethernet Switch Host Interface Driver	2014-09-23 03:59:13 -07:00