Under some conditions, irq sorting procedure used by INTC can go wrong
resulting in a spurious irq getting reported.
If this condition is not handled, it results in endless stream of:
unexpected IRQ trap at vector 00
messages from ack_bad_irq()
Handle the spurious interrupt condition in omap-intc driver to prevent this.
Measurements using kernel function profiler on AM335x EVM running at 720MHz
show that after this patch omap_intc_handle_irq() takes about 37.4us against
34us before this patch.
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Cc: John Ogness <john.ogness@linutronix.de>
Cc: Felipe Balbi <balbi@ti.com>
Cc: Jason Cooper <jason@lakedaemon.net>
Cc: Marc Zyngier <marc.zyngier@arm.com>
Link: http://lkml.kernel.org/r/9c78a6db02ac55f7af7371b417b6e414d2c3095b.1450188128.git.nsekhar@ti.com
Cc: stable@vger.kernel.org
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Some OMAP interrupt controllers use generic level detection, so
handle_level_irq() is used as the chip type handler.
Allocated IRQ chip type handler doesn't need to set it again because
irq_alloc_domain_generic_chips() has already registered it.
Tested with BeagleBoneBlack Rev C.
Signed-off-by: Milo Kim <milo.kim@ti.com>
Cc: Tony Lindgren <tony@atomide.com>
Cc: Jason Cooper <jason@lakedaemon.net>
Cc: Marc Zyngier <marc.zyngier@arm.com>
Cc: linux-omap@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Link: http://lkml.kernel.org/r/1450687994-12580-1-git-send-email-milo.kim@ti.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
As it turns out the current IRQ number will *always* be available from
SIR register which renders the reads of PENDING registers as plain
unnecessary overhead.
In order to catch any situation where SIR reads as zero, we're adding
a WARN() to turn it into a very verbose error and users actually
report it.
With this patch average running time of omap_intc_handle_irq() reduced
from about 28.5us to 19.8us as measured by the kernel function
profiler.
Tested with BeagleBoneBlack Rev A5C.
Tested-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Cc: Linux ARM Kernel Mailing List <linux-arm-kernel@lists.infradead.org>
Link: http://lkml.kernel.org/r/20150720204910.GH5394@saruman.tx.rr.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Nowadays omap2 is booting in device tree only mode so there is no
need to keep the legacy interface around for omap2_init_irq().
Signed-off-by: Tony Lindgren <tony@atomide.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
Cc: Jason Cooper <jason@lakedaemon.net>
Link: http://lkml.kernel.org/r/1421187806-6804-3-git-send-email-tony@atomide.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
On dm81xx we have 128 interrupts like am33xx has. Let's add
compatible flags for dm814x and dm816x, and document the
existing binding.
As the dm81xx are booting in device tree only mode, we can now
also remove ti81xx_init_irq() legacy function.
Signed-off-by: Tony Lindgren <tony@atomide.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
Cc: Brian Hutchinson <b.hutchman@gmail.com>
Cc: Jason Cooper <jason@lakedaemon.net>
Link: http://lkml.kernel.org/r/1421187806-6804-2-git-send-email-tony@atomide.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
commit 55601c9f24 (arm: omap: intc: switch over
to linear irq domain) introduced a regression with
SDMA legacy driver because that driver strictly depends
on INTC's IRQs starting at NR_IRQs. Aparently
irq_domain_add_linear() won't guarantee that, since we see
a 7 IRQs difference when booting with and without the
commit cited above.
Until arch/arm/plat-omap/dma.c is properly fixed, we
must maintain OMAP2/3 using irq_domain_add_legacy().
A FIXME note was added so people know to delete that
code once that legacy DMA driver is fixed up.
Fixes: 55601c9f24 (arm: omap: intc: switch over to linear irq domain)
Cc: <stable@vger.kernel.org> # v3.18
Tested-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Tested-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Link: https://lkml.kernel.org/r/1420576688-10604-1-git-send-email-balbi@ti.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
Pull irq updates from Thomas Gleixner:
"The irq departement delivers:
- a cleanup series to get rid of mindlessly copied code.
- another bunch of new pointlessly different interrupt chip drivers.
Adding homebrewn irq chips (and timers) to SoCs must provide a
value add which is beyond the imagination of mere mortals.
- the usual SoC irq controller updates, IOW my second cat herding
project"
* 'irq-core-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip: (44 commits)
irqchip: gic-v3: Implement CPU PM notifier
irqchip: gic-v3: Refactor gic_enable_redist to support both enabling and disabling
irqchip: renesas-intc-irqpin: Add minimal runtime PM support
irqchip: renesas-intc-irqpin: Add helper variable dev = &pdev->dev
irqchip: atmel-aic5: Add sama5d4 support
irqchip: atmel-aic5: The sama5d3 has 48 IRQs
Documentation: bcm7120-l2: Add Broadcom BCM7120-style L2 binding
irqchip: bcm7120-l2: Add Broadcom BCM7120-style Level 2 interrupt controller
irqchip: renesas-irqc: Add binding docs for new R-Car Gen2 SoCs
irqchip: renesas-irqc: Add DT binding documentation
irqchip: renesas-intc-irqpin: Document SoC-specific bindings
openrisc: Get rid of handle_IRQ
arm64: Get rid of handle_IRQ
ARM: omap2: irq: Convert to handle_domain_irq
ARM: imx: tzic: Convert to handle_domain_irq
ARM: imx: avic: Convert to handle_domain_irq
irqchip: or1k-pic: Convert to handle_domain_irq
irqchip: atmel-aic5: Convert to handle_domain_irq
irqchip: atmel-aic: Convert to handle_domain_irq
irqchip: gic-v3: Convert to handle_domain_irq
...
no fuctional changes.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
maximum number of MIR register is 4, rather than 3.
Fix that.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
When TURBO bit is set in the INTC_IDLE register,
the input synchronizer clock will be autogated
based on activity on the INTC.
Because this idle mode increases the interrupt
latency by 2 clock cycles, we're only enabling
it during suspend.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
When PROTECTION bit in enabled in PROTECTION
register, INTC's registers are only accessible
from privileged mode.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
of_iomap(), which is called from omap_init_irq_of(),
already takes care of making sure we have a valid
resource to deal with. Because of that, we can
safely remove our explicit call to of_address_to_resource().
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
no functional changes, just making sure comment
follows Coding Style.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
We already hold the number of Pending registers
in omap_nr_pending. Let's use that instead.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Just move the code over as it has no dependencies
on arch/arm/ anymore.
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
