The analog sticks of the pro-controller might report slightly off values.
To guarantee a uniform setup, we now calibrate analog-stick values during
pro-controller setup.
Unfortunately, the pro-controller fails during normal EEPROM reads and I
couldn't figure out whether there are any calibration values stored on the
device. Therefore, we now use the first values reported by the device (iff
they are not _way_ off, which would indicate movement) to initialize the
calibration values. To allow users to change this calibration data, we
provide a pro_calib sysfs attribute.
We also change the "flat" values so user-space correctly smoothes our
data. It makes slightly off zero-positions less visible while still
guaranteeing highly precise movement reports. Note that the pro controller
reports zero-positions in a quite huge range (at least: -100 to +100).
Reported-by: Rafael Brune <mail@rbrune.de>
Tested-by: Rafael Brune <mail@rbrune.de>
Signed-off-by: David Herrmann <dh.herrmann@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Balance-Boards provide 3 16bit calibration values for each of the 4
sensors. We provide these now as 192bit value via a new "bboard_calib"
sysfs attribute.
We also re-read the calibration data from the device whenever user-space
attempts to read this file. On normal Nintendo boards, this always
produces the same results, however, on some 3rd party devices these values
change until the device is fully initialized. As I have currently no idea
how long to wait until it's ready (sometimes takes up to 10s?) we provide
a simple workaround for users by reading this file.
If we, at some point, figure out how it works, we can implement it in the
kernel and provide offline data via "bboard_calib". This won't break
user-space then.
Signed-off-by: David Herrmann <dh.herrmann@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Two new attributes, "extension" and "devtype" now allow user-space to read
the extension type and device type. As device detection is asynchronous,
we send a CHANGED event after it is done. This also allows user-space to
wait for a device to settle before opening its input event devices.
The "extension" device is compatible with the old "extension" sysfs field
(which was registered by the static extension support code).
Signed-off-by: David Herrmann <dh.herrmann@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Add new sysfs attribute "extension" which returns the currently connected and
initialized extensions.
Signed-off-by: David Herrmann <dh.herrmann@googlemail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Add sysfs files for each led of the wiimote. Writing 1 to the file
enables the led and 0 disables the led.
We do not need memory barriers when checking wdata->ready since we use
a spinlock directly after it.
Signed-off-by: David Herrmann <dh.herrmann@googlemail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
