The HW hasn't been sold since 2005, and the SW has definite bit rot.
Its time to remove it. So move it to staging for a few releases and
then remove it after that.
Signed-off-by: Steve Wise <swise@opengridcomputing.com>
Signed-off-by: Doug Ledford <dledford@redhat.com>
It is now time for the ipath driver to begin to be phased out of the kernel.
This patch moves the ipath driver from the Infiniband sub tree to the staging
area where it will remain until the code is removed from the kernel in a few
releases.
Reviewed-by: Mike Marciniszyn <mike.marciniszyn@intel.com>
Signed-off-by: Dennis Dalessandro <dennis.dalessandro@intel.com>
Signed-off-by: Doug Ledford <dledford@redhat.com>
It is not possible to build only the drivers/infiniband/hw/ (or ulp/)
subdirectory with command such as:
$ make ARCH=x86_64 O=./obj-x86_64/ drivers/infiniband/hw/
This fails with following error messages:
make[2]: Nothing to be done for `all'.
make[2]: Nothing to be done for `relocs'.
CHK include/config/kernel.release
Using /home/ydroneaud/src/linux as source for kernel
GEN /home/ydroneaud/src/linux/obj-x86_64/Makefile
CHK include/generated/uapi/linux/version.h
CHK include/generated/utsrelease.h
CALL /home/ydroneaud/src/linux/scripts/checksyscalls.sh
/home/ydroneaud/src/linux/scripts/Makefile.build:44: /home/ydroneaud/src/linux/drivers/infiniband/hw/Makefile: No such file or directory
make[2]: *** No rule to make target `/home/ydroneaud/src/linux/drivers/infiniband/hw/Makefile'. Stop.
make[1]: *** [drivers/infiniband/hw/] Error 2
make: *** [sub-make] Error 2
This patch creates a Makefile in hw/ and ulp/ and moves each
corresponding parts of drivers/infiniband/Makefile in the new
Makefiles.
It should not break build except if some hw/ drivers or ulp/ were
allowed previously to be built while CONFIG_INFINIBAND is set to 'n',
but according to drivers/infiniband/Kconfig, it's not possible. So it
should be safe to apply.
Signed-off-by: Yann Droneaud <ydroneaud@opteya.com>
Reviewed-by: Bart Van Assche <bvanassche@acm.org>
Signed-off-by: Roland Dreier <roland@purestorage.com>
