Enable the XUSB controller on Jetson TX1. One of the USB 3.0 lanes goes
to an internal ethernet interface, while a second USB 3.0 lane supports
the USB-A receptacle on the I/O board.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Add power supplies for the SD/MMC card slot. Note that vmmc-supply is
currently restricted to 3.3 V because we don't support switching the
mode yet.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Add a device tree node for the MAX77620 PMIC found on the p2180
processor module (Jetson TX1). Also add supporting power supplies,
such as the main 5 V system supply.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Add a gpio-keys device tree node to represent the Power, Volume Up and
Volume Down keys found on Jetson TX1.
Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
When Tegra124 support was first merged the unit-addresses of all devices
were listed with a "0," prefix to encode the reg property's second cell.
It turns out that this notation is not correct, and the "," separator is
only used to separate fields in the unit address (such as the device and
function number in PCI devices), not individual cells for addresses with
more than one cell.
Signed-off-by: Thierry Reding <treding@nvidia.com>
The NVIDIA P2597 I/O board is a carrier board for the Jetson TX1 module
and together they are also known as the Jetson TX1 Developer Kit. The
I/O board provides an RJ45 connector routed to the network adapter that
is part of the Jetson TX1 module. It exposes many other connectors such
as SATA, USB 3.0, HDMI, JTAG and PCIe, among others, as well. Dedicated
connectors allow display and camera modules to be attached. A full-size
SD slot is provided to extend storage beyond the 32 GiB of eMMC found
on the Jetson TX1 module.
Signed-off-by: Thierry Reding <treding@nvidia.com>
