The x86_64 call_rwsem_wait() treats the active state counter part of the
R/W semaphore state as being 16-bit when it's actually 32-bit (it's half
of the 64-bit state). It should do "decl %edx" not "decw %dx".
Signed-off-by: David Howells <dhowells@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This one is much faster than the spinlock based fallback rwsem code,
with certain artifical benchmarks having shown 300%+ improvement on
threaded page faults etc.
Again, note the 32767-thread limit here. So this really does need that
whole "make rwsem_count_t be 64-bit and fix the BIAS values to match"
extension on top of it, but that is conceptually a totally independent
issue.
NOT TESTED! The original patch that this all was based on were tested by
KAMEZAWA Hiroyuki, but maybe I screwed up something when I created the
cleaned-up series, so caveat emptor..
Also note that it _may_ be a good idea to mark some more registers
clobbered on x86-64 in the inline asms instead of saving/restoring them.
They are inline functions, but they are only used in places where there
are not a lot of live registers _anyway_, so doing for example the
clobbers of %r8-%r11 in the asm wouldn't make the fast-path code any
worse, and would make the slow-path code smaller.
(Not that the slow-path really matters to that degree. Saving a few
unnecessary registers is the _least_ of our problems when we hit the slow
path. The instruction/cycle counting really only matters in the fast
path).
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
LKML-Reference: <alpine.LFD.2.00.1001121810410.17145@localhost.localdomain>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>