This patch adds a minimum support of Realtek ALC5670 codec.
Signed-off-by: Bard Liao <bardliao@realtek.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The implementation of rt5677_pll_calc() has the same logic of rl6231_pll_calc().
The only difference is the lower boundary checking for freq_in.
This patch calls rl6231_pll_calc() instead of open-coded.
The k_bp of struct rt5677_pll_code is always false, thus also remove the
code to check pll_code.k_bp.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Tested-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The patch replaces the string "micbias1" to "MICBIAS1".
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The patch adds the function "get_clk_info" to RL6231 shared support.
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The patch adds the function of the PLL clock calculation to RL6231 shared
support.
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The patch adds the RL6231 class device shared support for RT5640, RT5645 and
RT5651. The function of the DMIC clock calculation can be shared by RL6231
shared support.
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The mono output PGA input only has four possible sources, so
omit the rest.
Signed-off-by: Matt Reimer <mreimer@sdgsystems.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The new value argument needs proper shift to match the mask bit fields.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Tested-by: Brian Austin <brian.austin@cirrus.com>
Acked-by: Brian Austin <brian.austin@cirrus.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
For some unknown reason the parameters for snd_soc_test_bits() were in wrong
order:
It was:
snd_soc_test_bits(codec, val, mask, reg); /* WRONG!!! */
while it should be:
snd_soc_test_bits(codec, reg, mask, val);
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
Cc: stable@vger.kernel.org
WM8804 can run with PLL frequencies of 256xfs and 128xfs for
most sample rates. At 192kHz only 128xfs is supported. The
existing driver selects 128xfs automatically for some lower
samples rates. By using an additional mclk_div divider, it
is now possible to control the behaviour. This allows using
256xfs PLL frequency on all sample rates up to 96kHz. It
should allow lower jitter and better signal quality. The
behavior has to be controlled by the sound card driver,
because some sample frequency share the same setting. e.g.
192kHz and 96kHz use 24.576MHz master clock. The only
difference is the MCLK divider.
Signed-off-by: Daniel Matuschek <daniel@matuschek.net>
Tested-by: Florian Meier <florian.meier@koalo.de>
Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
This patch adds support for the Analog Devices ADAU1381 and ADAU1781 audio
CODECs. The device is a low-power, 24-bit stereo audio CODEC with multiple
analog inputs and outputs, two digital microphone inputs and an I2S interface.
The device can be controlled either using I2C or SPI. The main difference
between the two variants is that the ADAU1781 has a freely programmable SigmaDSP
processor, while the ADAU1381 has a fixed function wind noise reduction filter.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
This patch adds support for the Analog Devices ADAU1361 and ADAU1761 CODECs.
The device is a a low-power, 24-bit stereo audio CODEC with multiple analog
input and outputs, one digital microphone input and an I2S interface. The device
can be controlled either via I2C or SPI. The main difference between the two
variants is that the ADAU1761 has a built-in SigmaDSP, while the ADAU1361 has
not.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
The ADAU1X61 and ADAU1X81 are very similar in the digital domain, but are quite
different in the analog domain. This patch adds support for the common parts of
the ADAU1X61 and ADAU1X81 CODECs.
The patch also restores some of the alphabetical order in the Makfile and
Kconfig.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
We have defines for adsp messages best to consistently use them.
Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
Since commit e5d80e82e3 (ASoC: sgtl5000: Convert to use regmap directly) a
kernel oops is observed after a suspend/resume sequence.
The kernel oops happens inside sgtl5000_restore_regs() as codec->reg_cache is no
longer a valid pointer.
Add the remaining register entries into sgtl5000_reg_defaults[] and remove
sgtl5000_restore_regs() completely, which allows suspend/resume to work fine and
make the code simpler.
Tested on a im53-qsb board.
Reported-by: Shawn Guo <shawn.guo@freescale.com>
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Tested-by: Shawn Guo <shawn.guo@freescale.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
Having the binary ones complement operator in the new bitmak value makes the
code hard to read.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
If master clock is provided through device tree, then update
the master clock frequency during set_sysclk.
Documentation has been updated to reflect the change.
Signed-off-by: Tushar Behera <tushar.behera@linaro.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
If master clock is provided through device tree, then update
the master clock frequency during set_sysclk.
Documentation has been updated to reflect the change.
Signed-off-by: Tushar Behera <tushar.behera@linaro.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
Add "depends on I2C" to shut up the build errors from randconfig.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
This patch adds the clock divisor and multiplier NI, MI values for audio
sampling frequencies 44100 and 48000 Hz and PCLK 19.2 MHz. This is useful
for the Odroid X2/U2 boards when the codec works in master mode and its
MCLK clock is fed from the I2S CDCLK output.
Signed-off-by: Chen Zhen <zhen1.chen@samsung.com>
[s.nawrocki@samsung.com: edited the commit description]
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
A small set of driver fixes, nothing remarkable in itself or of any
relevance outside of the driver.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1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=0trh
-----END PGP SIGNATURE-----
Merge tag 'asoc-v3.15-rc5-drivers' into asoc-linus
ASoC: Driver fixes for v3.15
A small set of driver fixes, nothing remarkable in itself or of any
relevance outside of the driver.
# gpg: Signature made Wed 14 May 2014 12:49:57 BST using RSA key ID 7EA229BD
# gpg: Good signature from "Mark Brown <broonie@sirena.org.uk>"
# gpg: aka "Mark Brown <broonie@debian.org>"
# gpg: aka "Mark Brown <broonie@kernel.org>"
# gpg: aka "Mark Brown <broonie@tardis.ed.ac.uk>"
# gpg: aka "Mark Brown <broonie@linaro.org>"
# gpg: aka "Mark Brown <Mark.Brown@linaro.org>"
Let the ALC5623 codec be instantiated from DT. Add a simple binding
for the additional control register and the jack detect register.
Also, add a prompt to the Kconfig entry for this CODEC, so that it can
be selected. Since kirkwood-t5325.c will no longer be used, we need to
be able to enable the CODEC in the mvebu_v5_defconfig etc.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Mark Brown <broonie@linaro.org>
Using a proper do-while loop here instead of a open-coded goto loop is both
cleaner and shorter.
Also fixes the following warnings from smatch:
sound/soc/codecs/ad1980.c:213 ad1980_reset() info: loop could be replaced with if statement.
sound/soc/codecs/ad1980.c:212 ad1980_reset() info: ignoring unreachable code.
sound/soc/codecs/ad1980.c:215 ad1980_reset() info: ignoring unreachable code.
While we are at it also change retry_cnt to unsigned int, using u16 for a
on-stack loop counter doesn't make that much sense.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
