this patch adds support to the VLAN driver to translate IF_OPER_DORMANT of the
underlying device to netif_dormant_on(). Beside clean state forwarding, this
allows running independant userspace supplicants on both the real device and
the stacked VLAN. It depends on my RFC2863 patch.
Signed-off-by: Stefan Rompf <stefan@loplof.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
net: Use <linux/capability.h> where capable() is used.
Signed-off-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This changes some memcmp(one,two,ETH_ALEN) to compare_ether_addr(one,two).
Signed-off-by: Kris Katterjohn <kjak@users.sourceforge.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
In vlan_ioctl_handler() the code misses couple checks for
error return values.
Signed-off-by: Mika Kukkonen <mikukkon@iki.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
Receiving VLAN packets over a device (without VLAN assist) that is
doing hardware checksumming (CHECKSUM_HW), causes errors because the
VLAN code forgets to adjust the hardware checksum.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Bonding just wants the device before the skb_bond()
decapsulation occurs, so simply pass that original
device into packet_type->func() as an argument.
It remains to be seen whether we can use this same
exact thing to get rid of skb->input_dev as well.
Signed-off-by: David S. Miller <davem@davemloft.net>
OK, I can see what's happening here. eth0 doesn't detect link-up until
after a few seconds, so when the vlan interface is opened immediately
after eth0 has been opened, it inherits the link-down state. Subsequently
the vlan interface is never properly activated and are thus unable to
transmit any packets.
dev->state bits are not supposed to be manipulated directly. Something
similar is probably needed for the netif_device_present() bit, although
I don't know how this is meant to work for a virtual device.
Signed-off-by: David S. Miller <davem@davemloft.net>
Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.
The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.
Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
There were still a few comments left refering to verify_area, and two
functions, verify_area_skas & verify_area_tt that just wrap corresponding
access_ok_skas & access_ok_tt functions, just like verify_area does for
access_ok - deprecate those.
There was also a few places that still used verify_area in commented-out
code, fix those up to use access_ok.
After applying this one there should not be anything left but finally
removing verify_area completely, which will happen after a kernel release
or two.
Signed-off-by: Jesper Juhl <juhl-lkml@dif.dk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
