The cs4265 driver is missing a microphone preamp enable.
This patch enables/disables the microphone preamp when mic
selection is made using the kcontrol.
Signed-off-by: Matt Flax <flatmax@flatmax.org>
Reviewed-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds a S/PDIF enable switch as a SOC_SINGLE.
Signed-off-by: Matt Flax <flatmax@flatmax.org>
Reviewed-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The cs4265 uses 32 bit transport on the I2S bus. This patch enables native
32 bit mode for machine drivers which use this sound card driver.
Signed-off-by: Matt Flax <flatmax@flatmax.org>
Reviewed-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The cs4265 driver declares the "MMTLR Data Switch" register setting with
a 0 register value rather then the 0x12 register (CS4265_SPDIF_CTL2).
This incorrect value causes alsamixer to fault with the output :
cannot load mixer controls: Input/output error
This patch corrects the register value. alsamixer now runs.
Signed-off-by: Matt Flax <flatmax@flatmax.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
codec driver and component driver has duplicated callback functions,
and codec side functions are just copied to component side when
register timing. This was quick-hack, but no longer needed.
This patch moves these functions from codec driver to component driver.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
CS4265_INT_STATUS was missed in cs4265_readable_register, fix it.
The register 0x01 ~ 0x12 are readable, use
CS4265_CHIP_ID ... CS4265_SPDIF_CTL2 syntax for better readability.
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The settings in current code does not match the datasheet, fix it.
DAC Control - Address 03h
DAC Digital Interface Format (Bits 5:4)
DAC_DIF1 DAC_DIF0 Description
0 0 Left Justified, up to 24-bit data (default)
0 1 I²S, up to 24-bit data
1 0 Right-Justified, 16-bit Data
1 1 Right-Justified, 24-bit Data
Transmitter Control 2 - Address 12h
Transmitter Digital Interface Format (Bits 7:6)
Tx_DIF1 Tx_DIF0 Description Format Figure
0 0 Left Justified, up to 24-bit data (default)
0 1 I²S, up to 24-bit data
1 0 Right-Justified, 16-bit Data
1 1 Right-Justified, 24-bit Data
Signed-off-by: Axel Lin <axel.lin@ingics.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
i2c_driver does not need to set an owner because i2c_register_driver()
will set it.
Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
All drivers have the same line at the end of the set_bias_level callback to
update the bias_level state. Move this update into
snd_soc_dapm_force_bias_level() and remove them from the drivers.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@kernel.org>
Since 39b2bbe3d7 (gpio: add flags argument to gpiod_get*() functions)
which appeared in v3.17-rc1, the gpiod_get* functions take an additional
parameter that allows to specify direction and initial value for
output. Simplify drivers accordingly.
Also there is an *_optional variant that serves well here. The sematics
is slightly changed here by using it as error checking is more strict
now: If GPIOLIB is not enabled an error is returned instead of just
ignoring the gpio. On one hand this is bad for devices that don't "have"
the respective gpio as the driver is failing now. On the other hand
there is no means to assert that this gpio is really not needed or if
only the driver to control it is not available. The latter is a real
reason to fail and so it's defensive to fail here, too.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Mark Brown <broonie@kernel.org>
The SPDIF control register must be written to set the data type in hw_params
not the ADC control register.
Signed-off-by: Paul Handrigan <Paul.Handrigan@cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org
Reported-by: Zoltán Szenczi <zoltan@raspberrypi.org>
Signed-off-by: Paul Handrigan <Paul.Handrigan@cirrus.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
Cc: stable@vger.kernel.org
Reported-by: Zoltán Szenczi <zoltan@raspberrypi.org>
Signed-off-by: Paul Handrigan <Paul.Handrigan@cirrus.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
Cc: stable@vger.kernel.org
Reported-by: Zoltán Szenczi <zoltan@raspberrypi.org>
Signed-off-by: Paul Handrigan <Paul.Handrigan@cirrus.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
The CODEC doesn't care how data is laid out in memory.
Signed-off-by: Mark Brown <broonie@linaro.org>
Acked-by: Paul Handrigan <Paul.Handrigan@cirrus.com>
The cs4265_volatile_register reutrns a bool. The function now returns
true or false vs 1 and 0.
Signed-off-by: Paul Handrigan <Paul.Handrigan@cirrus.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
This patch adds support for the Cirrus Logic CS4265 Stereo I2C CODEC.
Signed-off-by: Paul Handrigan <paul.handrigan@cirrus.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
