Currently, we don't coordinate BT USB activity with our handling of the
BT out-of-band wake pin, and instead just use gpio-keys. That causes
problems because we have no way of distinguishing wake activity due to a
BT device (e.g., mouse) vs. the BT controller (e.g., re-configuring wake
mask before suspend). This can cause spurious wake events just because
we, for instance, try to reconfigure the host controller's event mask
before suspending.
We can avoid these synchronization problems by handling the BT wake pin
directly in the btusb driver -- for all activity up until BT controller
suspend(), we simply listen to normal USB activity (e.g., to know the
difference between device and host activity); once we're really ready to
suspend the host controller, there should be no more host activity, and
only *then* do we unmask the GPIO interrupt.
This is already supported by btusb; we just need to describe the wake
pin in the right node.
We list 2 compatible properties, since both PID/VID pairs show up on
Scarlet devices, and they're both essentially identical QCA6174A-based
modules.
Also note that the polarity was wrong before: Qualcomm implemented WAKE
as active high, not active low. We only got away with this because
gpio-keys always reconfigured us as bi-directional edge-triggered.
Finally, we have an external pull-up and a level-shifter on this line
(we didn't notice Qualcomm's polarity in the initial design), so we
can't do pull-down. Switch to pull-none.
Signed-off-by: Brian Norris <briannorris@chromium.org>
Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
After commit 88ba95bedb ("backlight: pwm_bl: Compute brightness of LED
linearly to human eye") the pwm_bl driver is able to calculate a default
brightness table. The calculated table for this PWM will have more
granularity and will be adjusted to change the brightness linearly to
the human eye. Use that table instead of have a DT-defined table with
less granularity.
Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Bob needs the same backlight and core edp settings, so move these nodes to
the shared dtsi that both will use as a base.
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Similar to rk3288-Veyron before, the Gru-series does contain Chromebook
(aka clamshell laptops) and non-Chromebook devices. And while the two
Chromebook devices Kevin and Bob are quite similar, Scarlet the tablet-
device is quite different in its design.
Therefore move the Chromebook parts into a gru-chromebook dtsi file
to make sharing easier.
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
