mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-23 02:43:03 +07:00
net: pxa168_eth: Remove in-driver PHY mangling
With properly using libphy PHYs now, remove the in-driver PHY mangling. Tested-by: Antoine Ténart <antoine.tenart@free-electrons.com> Reviewed-by: Florian Fainelli <f.fainelli@gmail.com> Signed-off-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
parent
1a14913289
commit
9ff32fe1b9
@ -177,7 +177,6 @@
|
||||
#define LINK_UP (1 << 3)
|
||||
|
||||
/* Bit definitions for work to be done */
|
||||
#define WORK_LINK (1 << 0)
|
||||
#define WORK_TX_DONE (1 << 1)
|
||||
|
||||
/*
|
||||
@ -284,7 +283,6 @@ static void eth_port_reset(struct net_device *dev);
|
||||
static void eth_port_start(struct net_device *dev);
|
||||
static int pxa168_eth_open(struct net_device *dev);
|
||||
static int pxa168_eth_stop(struct net_device *dev);
|
||||
static int ethernet_phy_setup(struct net_device *dev);
|
||||
|
||||
static inline u32 rdl(struct pxa168_eth_private *pep, int offset)
|
||||
{
|
||||
@ -316,26 +314,6 @@ static void abort_dma(struct pxa168_eth_private *pep)
|
||||
netdev_err(pep->dev, "%s : DMA Stuck\n", __func__);
|
||||
}
|
||||
|
||||
static int ethernet_phy_get(struct pxa168_eth_private *pep)
|
||||
{
|
||||
unsigned int reg_data;
|
||||
|
||||
reg_data = rdl(pep, PHY_ADDRESS);
|
||||
|
||||
return (reg_data >> (5 * pep->port_num)) & 0x1f;
|
||||
}
|
||||
|
||||
static void ethernet_phy_set_addr(struct pxa168_eth_private *pep, int phy_addr)
|
||||
{
|
||||
u32 reg_data;
|
||||
int addr_shift = 5 * pep->port_num;
|
||||
|
||||
reg_data = rdl(pep, PHY_ADDRESS);
|
||||
reg_data &= ~(0x1f << addr_shift);
|
||||
reg_data |= (phy_addr & 0x1f) << addr_shift;
|
||||
wrl(pep, PHY_ADDRESS, reg_data);
|
||||
}
|
||||
|
||||
static void rxq_refill(struct net_device *dev)
|
||||
{
|
||||
struct pxa168_eth_private *pep = netdev_priv(dev);
|
||||
@ -890,43 +868,9 @@ static int pxa168_eth_collect_events(struct pxa168_eth_private *pep,
|
||||
}
|
||||
if (icr & ICR_RXBUF)
|
||||
ret = 1;
|
||||
if (icr & ICR_MII_CH) {
|
||||
pep->work_todo |= WORK_LINK;
|
||||
ret = 1;
|
||||
}
|
||||
return ret;
|
||||
}
|
||||
|
||||
static void handle_link_event(struct pxa168_eth_private *pep)
|
||||
{
|
||||
struct net_device *dev = pep->dev;
|
||||
u32 port_status;
|
||||
int speed;
|
||||
int duplex;
|
||||
int fc;
|
||||
|
||||
port_status = rdl(pep, PORT_STATUS);
|
||||
if (!(port_status & LINK_UP)) {
|
||||
if (netif_carrier_ok(dev)) {
|
||||
netdev_info(dev, "link down\n");
|
||||
netif_carrier_off(dev);
|
||||
txq_reclaim(dev, 1);
|
||||
}
|
||||
return;
|
||||
}
|
||||
if (port_status & PORT_SPEED_100)
|
||||
speed = 100;
|
||||
else
|
||||
speed = 10;
|
||||
|
||||
duplex = (port_status & FULL_DUPLEX) ? 1 : 0;
|
||||
fc = (port_status & FLOW_CONTROL_DISABLED) ? 0 : 1;
|
||||
netdev_info(dev, "link up, %d Mb/s, %s duplex, flow control %sabled\n",
|
||||
speed, duplex ? "full" : "half", fc ? "en" : "dis");
|
||||
if (!netif_carrier_ok(dev))
|
||||
netif_carrier_on(dev);
|
||||
}
|
||||
|
||||
static irqreturn_t pxa168_eth_int_handler(int irq, void *dev_id)
|
||||
{
|
||||
struct net_device *dev = (struct net_device *)dev_id;
|
||||
@ -1307,10 +1251,6 @@ static int pxa168_rx_poll(struct napi_struct *napi, int budget)
|
||||
struct net_device *dev = pep->dev;
|
||||
int work_done = 0;
|
||||
|
||||
if (unlikely(pep->work_todo & WORK_LINK)) {
|
||||
pep->work_todo &= ~(WORK_LINK);
|
||||
handle_link_event(pep);
|
||||
}
|
||||
/*
|
||||
* We call txq_reclaim every time since in NAPI interupts are disabled
|
||||
* and due to this we miss the TX_DONE interrupt,which is not updated in
|
||||
@ -1433,72 +1373,6 @@ static int pxa168_eth_do_ioctl(struct net_device *dev, struct ifreq *ifr,
|
||||
return -EOPNOTSUPP;
|
||||
}
|
||||
|
||||
static struct phy_device *phy_scan(struct pxa168_eth_private *pep, int phy_addr)
|
||||
{
|
||||
struct mii_bus *bus = pep->smi_bus;
|
||||
struct phy_device *phydev;
|
||||
int start;
|
||||
int num;
|
||||
int i;
|
||||
|
||||
if (phy_addr == PXA168_ETH_PHY_ADDR_DEFAULT) {
|
||||
/* Scan entire range */
|
||||
start = ethernet_phy_get(pep);
|
||||
num = 32;
|
||||
} else {
|
||||
/* Use phy addr specific to platform */
|
||||
start = phy_addr & 0x1f;
|
||||
num = 1;
|
||||
}
|
||||
phydev = NULL;
|
||||
for (i = 0; i < num; i++) {
|
||||
int addr = (start + i) & 0x1f;
|
||||
if (bus->phy_map[addr] == NULL)
|
||||
mdiobus_scan(bus, addr);
|
||||
|
||||
if (phydev == NULL) {
|
||||
phydev = bus->phy_map[addr];
|
||||
if (phydev != NULL)
|
||||
ethernet_phy_set_addr(pep, addr);
|
||||
}
|
||||
}
|
||||
|
||||
return phydev;
|
||||
}
|
||||
|
||||
static void phy_init(struct pxa168_eth_private *pep)
|
||||
{
|
||||
struct phy_device *phy = pep->phy;
|
||||
|
||||
phy_attach(pep->dev, dev_name(&phy->dev), pep->phy_intf);
|
||||
|
||||
phy->speed = pep->phy_speed;
|
||||
phy->duplex = pep->phy_duplex;
|
||||
phy->autoneg = AUTONEG_ENABLE;
|
||||
phy->supported &= PHY_BASIC_FEATURES;
|
||||
phy->advertising = phy->supported | ADVERTISED_Autoneg;
|
||||
|
||||
if (pep->phy_speed != 0) {
|
||||
phy->autoneg = AUTONEG_DISABLE;
|
||||
phy->advertising = 0;
|
||||
}
|
||||
|
||||
phy_start_aneg(phy);
|
||||
}
|
||||
|
||||
static int ethernet_phy_setup(struct net_device *dev)
|
||||
{
|
||||
struct pxa168_eth_private *pep = netdev_priv(dev);
|
||||
|
||||
pep->phy = phy_scan(pep, pep->phy_addr & 0x1f);
|
||||
if (pep->phy != NULL)
|
||||
phy_init(pep);
|
||||
|
||||
update_hash_table_mac_address(pep, NULL, dev->dev_addr);
|
||||
|
||||
return 0;
|
||||
}
|
||||
|
||||
static int pxa168_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
|
||||
{
|
||||
struct pxa168_eth_private *pep = netdev_priv(dev);
|
||||
|
Loading…
Reference in New Issue
Block a user