mirror of
https://github.com/AuxXxilium/linux_dsm_epyc7002.git
synced 2024-12-15 14:46:45 +07:00
r8169: remove old PHY reset hack
This hack (affecting the non-PCIe models only) was introduced in 2004 to deal with link negotiation failures in 1GBit mode. Based on a comment in the r8169 vendor driver I assume the issue affects RTL8169sb in combination with particular 1GBit switch models. Resetting the PHY every 10s and hoping that one fine day we will make it to establish the link seems to be very hacky to me. I'd say: If 1GBit doesn't work reliably in a users environment then the user should remove 1GBit from the advertised modes, e.g. by using ethtool -s <if> advertise <10/100 modes> If the issue affects one chip version only and that with most link partners, then we could also think of removing 1GBit from the advertised modes for this chip version in the driver. Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
parent
c02462d8a3
commit
335c997dce
@ -80,7 +80,6 @@ static const int multicast_filter_limit = 32;
|
||||
#define R8169_RX_RING_BYTES (NUM_RX_DESC * sizeof(struct RxDesc))
|
||||
|
||||
#define RTL8169_TX_TIMEOUT (6*HZ)
|
||||
#define RTL8169_PHY_TIMEOUT (10*HZ)
|
||||
|
||||
/* write/read MMIO register */
|
||||
#define RTL_W8(tp, reg, val8) writeb((val8), tp->mmio_addr + (reg))
|
||||
@ -703,7 +702,6 @@ enum rtl_flag {
|
||||
RTL_FLAG_TASK_ENABLED,
|
||||
RTL_FLAG_TASK_SLOW_PENDING,
|
||||
RTL_FLAG_TASK_RESET_PENDING,
|
||||
RTL_FLAG_TASK_PHY_PENDING,
|
||||
RTL_FLAG_MAX
|
||||
};
|
||||
|
||||
@ -731,7 +729,6 @@ struct rtl8169_private {
|
||||
dma_addr_t RxPhyAddr;
|
||||
void *Rx_databuff[NUM_RX_DESC]; /* Rx data buffers */
|
||||
struct ring_info tx_skb[NUM_TX_DESC]; /* Tx data buffers */
|
||||
struct timer_list timer;
|
||||
u16 cp_cmd;
|
||||
|
||||
u16 event_slow;
|
||||
@ -1788,20 +1785,7 @@ static int rtl8169_set_speed_xmii(struct net_device *dev,
|
||||
static int rtl8169_set_speed(struct net_device *dev,
|
||||
u8 autoneg, u16 speed, u8 duplex, u32 advertising)
|
||||
{
|
||||
struct rtl8169_private *tp = netdev_priv(dev);
|
||||
int ret;
|
||||
|
||||
ret = rtl8169_set_speed_xmii(dev, autoneg, speed, duplex, advertising);
|
||||
if (ret < 0)
|
||||
goto out;
|
||||
|
||||
if (netif_running(dev) && (autoneg == AUTONEG_ENABLE) &&
|
||||
(advertising & ADVERTISED_1000baseT_Full) &&
|
||||
!pci_is_pcie(tp->pci_dev)) {
|
||||
mod_timer(&tp->timer, jiffies + RTL8169_PHY_TIMEOUT);
|
||||
}
|
||||
out:
|
||||
return ret;
|
||||
return rtl8169_set_speed_xmii(dev, autoneg, speed, duplex, advertising);
|
||||
}
|
||||
|
||||
static netdev_features_t rtl8169_fix_features(struct net_device *dev,
|
||||
@ -1888,8 +1872,6 @@ static int rtl8169_set_link_ksettings(struct net_device *dev,
|
||||
cmd->link_modes.advertising))
|
||||
return -EINVAL;
|
||||
|
||||
del_timer_sync(&tp->timer);
|
||||
|
||||
rtl_lock_work(tp);
|
||||
rc = rtl8169_set_speed(dev, cmd->base.autoneg, cmd->base.speed,
|
||||
cmd->base.duplex, advertising);
|
||||
@ -4293,44 +4275,12 @@ static void rtl_hw_phy_config(struct net_device *dev)
|
||||
}
|
||||
}
|
||||
|
||||
static void rtl_phy_work(struct rtl8169_private *tp)
|
||||
{
|
||||
struct timer_list *timer = &tp->timer;
|
||||
unsigned long timeout = RTL8169_PHY_TIMEOUT;
|
||||
|
||||
if (rtl8169_xmii_reset_pending(tp)) {
|
||||
/*
|
||||
* A busy loop could burn quite a few cycles on nowadays CPU.
|
||||
* Let's delay the execution of the timer for a few ticks.
|
||||
*/
|
||||
timeout = HZ/10;
|
||||
goto out_mod_timer;
|
||||
}
|
||||
|
||||
if (rtl8169_xmii_link_ok(tp))
|
||||
return;
|
||||
|
||||
netif_dbg(tp, link, tp->dev, "PHY reset until link up\n");
|
||||
|
||||
rtl8169_xmii_reset_enable(tp);
|
||||
|
||||
out_mod_timer:
|
||||
mod_timer(timer, jiffies + timeout);
|
||||
}
|
||||
|
||||
static void rtl_schedule_task(struct rtl8169_private *tp, enum rtl_flag flag)
|
||||
{
|
||||
if (!test_and_set_bit(flag, tp->wk.flags))
|
||||
schedule_work(&tp->wk.work);
|
||||
}
|
||||
|
||||
static void rtl8169_phy_timer(struct timer_list *t)
|
||||
{
|
||||
struct rtl8169_private *tp = from_timer(tp, t, timer);
|
||||
|
||||
rtl_schedule_task(tp, RTL_FLAG_TASK_PHY_PENDING);
|
||||
}
|
||||
|
||||
DECLARE_RTL_COND(rtl_phy_reset_cond)
|
||||
{
|
||||
return rtl8169_xmii_reset_pending(tp);
|
||||
@ -6909,7 +6859,6 @@ static void rtl_task(struct work_struct *work)
|
||||
/* XXX - keep rtl_slow_event_work() as first element. */
|
||||
{ RTL_FLAG_TASK_SLOW_PENDING, rtl_slow_event_work },
|
||||
{ RTL_FLAG_TASK_RESET_PENDING, rtl_reset_work },
|
||||
{ RTL_FLAG_TASK_PHY_PENDING, rtl_phy_work }
|
||||
};
|
||||
struct rtl8169_private *tp =
|
||||
container_of(work, struct rtl8169_private, wk.work);
|
||||
@ -6982,8 +6931,6 @@ static void rtl8169_down(struct net_device *dev)
|
||||
{
|
||||
struct rtl8169_private *tp = netdev_priv(dev);
|
||||
|
||||
del_timer_sync(&tp->timer);
|
||||
|
||||
napi_disable(&tp->napi);
|
||||
netif_stop_queue(dev);
|
||||
|
||||
@ -7694,8 +7641,6 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
|
||||
tp->event_slow = cfg->event_slow;
|
||||
tp->coalesce_info = cfg->coalesce_info;
|
||||
|
||||
timer_setup(&tp->timer, rtl8169_phy_timer, 0);
|
||||
|
||||
tp->rtl_fw = RTL_FIRMWARE_UNKNOWN;
|
||||
|
||||
tp->counters = dmam_alloc_coherent (&pdev->dev, sizeof(*tp->counters),
|
||||
|
Loading…
Reference in New Issue
Block a user