Merge remote-tracking branches 'spi/fix/bcm63xx', 'spi/fix/dspi', 'spi/fix/hspi', 'spi/fix/imx', 'spi/fix/msiof', 'spi/fix/pxa2xx', 'spi/fix/qspi', 'spi/topic/altera', 'spi/topic/ath79' and 'spi/topic/atmel' into spi-linus

drivers/spi/spi-altera.c

@@ -220,8 +220,6 @@ static int altera_spi_probe(struct platform_device *pdev)
 
 	/* setup the state for the bitbang driver */
 	hw->bitbang.master = master;
-	if (!hw->bitbang.master)
-		return err;
 	hw->bitbang.chipselect = altera_spi_chipsel;
 	hw->bitbang.txrx_bufs = altera_spi_txrx;
 

drivers/spi/spi-ath79.c

@@ -243,21 +243,21 @@ static int ath79_spi_probe(struct platform_device *pdev)
 		goto err_put_master;
 	}
 
-	sp->base = ioremap(r->start, resource_size(r));
+	sp->base = devm_ioremap(&pdev->dev, r->start, resource_size(r));
 	if (!sp->base) {
 		ret = -ENXIO;
 		goto err_put_master;
 	}
 
-	sp->clk = clk_get(&pdev->dev, "ahb");
+	sp->clk = devm_clk_get(&pdev->dev, "ahb");
 	if (IS_ERR(sp->clk)) {
 		ret = PTR_ERR(sp->clk);
-		goto err_unmap;
+		goto err_put_master;
 	}
 
 	ret = clk_enable(sp->clk);
 	if (ret)
-		goto err_clk_put;
+		goto err_put_master;
 
 	rate = DIV_ROUND_UP(clk_get_rate(sp->clk), MHZ);
 	if (!rate) {
@@ -280,10 +280,6 @@ static int ath79_spi_probe(struct platform_device *pdev)
 	ath79_spi_disable(sp);
 err_clk_disable:
 	clk_disable(sp->clk);
-err_clk_put:
-	clk_put(sp->clk);
-err_unmap:
-	iounmap(sp->base);
 err_put_master:
 	spi_master_put(sp->bitbang.master);
 
@@ -297,8 +293,6 @@ static int ath79_spi_remove(struct platform_device *pdev)
 	spi_bitbang_stop(&sp->bitbang);
 	ath79_spi_disable(sp);
 	clk_disable(sp->clk);
-	clk_put(sp->clk);
-	iounmap(sp->base);
 	spi_master_put(sp->bitbang.master);
 
 	return 0;

drivers/spi/spi-bcm63xx.c

@@ -169,8 +169,6 @@ static int bcm63xx_txrx_bufs(struct spi_device *spi, struct spi_transfer *first,
 			       transfer_list);
 	}
 
-	len -= prepend_len;
-
 	init_completion(&bs->done);
 
 	/* Fill in the Message control register */

drivers/spi/spi-fsl-dspi.c

@@ -320,8 +320,10 @@ static void dspi_chipselect(struct spi_device *spi, int value)
 	switch (value) {
 	case BITBANG_CS_ACTIVE:
 		pushr |= SPI_PUSHR_CONT;
+		break;
 	case BITBANG_CS_INACTIVE:
 		pushr &= ~SPI_PUSHR_CONT;
+		break;
 	}
 
 	writel(pushr, dspi->base + SPI_PUSHR);

drivers/spi/spi-imx.c

@@ -206,7 +206,8 @@ static unsigned int spi_imx_clkdiv_2(unsigned int fin,
 #define MX51_ECSPI_STAT_RR		(1 <<  3)
 
 /* MX51 eCSPI */
-static unsigned int mx51_ecspi_clkdiv(unsigned int fin, unsigned int fspi)
+static unsigned int mx51_ecspi_clkdiv(unsigned int fin, unsigned int fspi,
+				      unsigned int *fres)
 {
 	/*
 	 * there are two 4-bit dividers, the pre-divider divides by
@@ -234,6 +235,10 @@ static unsigned int mx51_ecspi_clkdiv(unsigned int fin, unsigned int fspi)
 
 	pr_debug("%s: fin: %u, fspi: %u, post: %u, pre: %u\n",
 			__func__, fin, fspi, post, pre);
+
+	/* Resulting frequency for the SCLK line. */
+	*fres = (fin / (pre + 1)) >> post;
+
 	return (pre << MX51_ECSPI_CTRL_PREDIV_OFFSET) |
 		(post << MX51_ECSPI_CTRL_POSTDIV_OFFSET);
 }
@@ -264,6 +269,7 @@ static int __maybe_unused mx51_ecspi_config(struct spi_imx_data *spi_imx,
 		struct spi_imx_config *config)
 {
 	u32 ctrl = MX51_ECSPI_CTRL_ENABLE, cfg = 0;
+	u32 clk = config->speed_hz, delay;
 
 	/*
 	 * The hardware seems to have a race condition when changing modes. The
@@ -275,7 +281,7 @@ static int __maybe_unused mx51_ecspi_config(struct spi_imx_data *spi_imx,
 	ctrl |= MX51_ECSPI_CTRL_MODE_MASK;
 
 	/* set clock speed */
-	ctrl |= mx51_ecspi_clkdiv(spi_imx->spi_clk, config->speed_hz);
+	ctrl |= mx51_ecspi_clkdiv(spi_imx->spi_clk, config->speed_hz, &clk);
 
 	/* set chip select to use */
 	ctrl |= MX51_ECSPI_CTRL_CS(config->cs);
@@ -297,6 +303,23 @@ static int __maybe_unused mx51_ecspi_config(struct spi_imx_data *spi_imx,
 	writel(ctrl, spi_imx->base + MX51_ECSPI_CTRL);
 	writel(cfg, spi_imx->base + MX51_ECSPI_CONFIG);
 
+	/*
+	 * Wait until the changes in the configuration register CONFIGREG
+	 * propagate into the hardware. It takes exactly one tick of the
+	 * SCLK clock, but we will wait two SCLK clock just to be sure. The
+	 * effect of the delay it takes for the hardware to apply changes
+	 * is noticable if the SCLK clock run very slow. In such a case, if
+	 * the polarity of SCLK should be inverted, the GPIO ChipSelect might
+	 * be asserted before the SCLK polarity changes, which would disrupt
+	 * the SPI communication as the device on the other end would consider
+	 * the change of SCLK polarity as a clock tick already.
+	 */
+	delay = (2 * 1000000) / clk;
+	if (likely(delay < 10))	/* SCLK is faster than 100 kHz */
+		udelay(delay);
+	else			/* SCLK is _very_ slow */
+		usleep_range(delay, delay + 10);
+
 	return 0;
 }
 

drivers/spi/spi-pxa2xx.c

@@ -1066,6 +1066,8 @@ pxa2xx_spi_acpi_get_pdata(struct platform_device *pdev)
 
 	pdata->num_chipselect = 1;
 	pdata->enable_dma = true;
+	pdata->tx_chan_id = -1;
+	pdata->rx_chan_id = -1;
 
 	return pdata;
 }

drivers/spi/spi-sh-hspi.c

@@ -353,4 +353,4 @@ module_platform_driver(hspi_driver);
 MODULE_DESCRIPTION("SuperH HSPI bus driver");
 MODULE_LICENSE("GPL");
 MODULE_AUTHOR("Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>");
-MODULE_ALIAS("platform:sh_spi");
+MODULE_ALIAS("platform:sh-hspi");

drivers/spi/spi-sh-msiof.c

@@ -152,7 +152,7 @@ static void sh_msiof_spi_set_clk_regs(struct sh_msiof_spi_priv *p,
 	size_t k;
 
 	if (!WARN_ON(!spi_hz || !parent_rate))
-		div = parent_rate / spi_hz;
+		div = DIV_ROUND_UP(parent_rate, spi_hz);
 
 	/* TODO: make more fine grained */
 

drivers/spi/spi-ti-qspi.c

@@ -417,10 +417,8 @@ static irqreturn_t ti_qspi_isr(int irq, void *dev_id)
 static int ti_qspi_runtime_resume(struct device *dev)
 {
 	struct ti_qspi      *qspi;
-	struct spi_master       *master;
 
-	master = dev_get_drvdata(dev);
-	qspi = spi_master_get_devdata(master);
+	qspi = dev_get_drvdata(dev);
 	ti_qspi_restore_ctx(qspi);
 
 	return 0;
@@ -516,13 +514,9 @@ static int ti_qspi_probe(struct platform_device *pdev)
 
 static int ti_qspi_remove(struct platform_device *pdev)
 {
-	struct spi_master *master;
-	struct ti_qspi *qspi;
+	struct ti_qspi *qspi = platform_get_drvdata(pdev);
 	int ret;
 
-	master = platform_get_drvdata(pdev);
-	qspi = spi_master_get_devdata(master);
-
 	ret = pm_runtime_get_sync(qspi->dev);
 	if (ret < 0) {
 		dev_err(qspi->dev, "pm_runtime_get_sync() failed\n");
@@ -534,8 +528,6 @@ static int ti_qspi_remove(struct platform_device *pdev)
 	pm_runtime_put(qspi->dev);
 	pm_runtime_disable(&pdev->dev);
 
-	spi_unregister_master(master);
-
 	return 0;
 }