linux_dsm_epyc7002/Documentation/devicetree/bindings/spi/nvidia,tegra114-spi.txt

NVIDIA Tegra114 SPI controller.

Required properties:
- compatible : For Tegra114, must contain "nvidia,tegra114-spi".
  Otherwise, must contain '"nvidia,<chip>-spi", "nvidia,tegra114-spi"' where
  <chip> is tegra124, tegra132, or tegra210.
- reg: Should contain SPI registers location and length.
- interrupts: Should contain SPI interrupts.
- clock-names : Must include the following entries:
  - spi
- resets : Must contain an entry for each entry in reset-names.
  See ../reset/reset.txt for details.
- reset-names : Must include the following entries:
  - spi
- dmas : Must contain an entry for each entry in clock-names.
  See ../dma/dma.txt for details.
- dma-names : Must include the following entries:
  - rx
  - tx
- clocks : Must contain an entry for each entry in clock-names.
  See ../clocks/clock-bindings.txt for details.

Recommended properties:
- spi-max-frequency: Definition as per
                     Documentation/devicetree/bindings/spi/spi-bus.txt
Optional properties:
- nvidia,tx-clk-tap-delay: Delays the clock going out to the external device
  with this tap value. This property is used to tune the outgoing data from
  Tegra SPI master with respect to outgoing Tegra SPI master clock.
  Tap values vary based on the platform design trace lengths from Tegra SPI
  to corresponding slave devices. Valid tap values are from 0 thru 63.
- nvidia,rx-clk-tap-delay: Delays the clock coming in from the external device
  with this tap value. This property is used to adjust the Tegra SPI master
  clock with respect to the data from the SPI slave device.
  Tap values vary based on the platform design trace lengths from Tegra SPI
  to corresponding slave devices. Valid tap values are from 0 thru 63.

Example:

spi@7000d600 {
	compatible = "nvidia,tegra114-spi";
	reg = <0x7000d600 0x200>;
	interrupts = <0 82 0x04>;
	spi-max-frequency = <25000000>;
	#address-cells = <1>;
	#size-cells = <0>;
	clocks = <&tegra_car 44>;
	clock-names = "spi";
	resets = <&tegra_car 44>;
	reset-names = "spi";
	dmas = <&apbdma 16>, <&apbdma 16>;
	dma-names = "rx", "tx";
	<spi-client>@<bus_num> {
		...
		...
		nvidia,rx-clk-tap-delay = <0>;
		nvidia,tx-clk-tap-delay = <16>;
		...
	};

};